Rep1 COFDM Relay Module

 — COFDM demodulation and re-modulation
    — Stable signal transfer in NLOS and high speed moving
    — Adjustable working frequency, band width, transmission power, etc

Rep1 relay module accepts COFDM signals from two antennas(can just use one too) and demodulates it, then re-modulates and transmits. The relay module can find and lock automatically to the incoming transmission quickly according to the pre-set frequency and bandwidth.

Specification:

IO

RF input	Two SMA female
RF output	MMCX female
control uart	4PIN PH1.25mm Connector
Power in	2PIN PH2.54mm phenix Connector
TF-card	For firmware update
Power led	red led, constant light when device is normal powered
Link led	green led, blinks on transmitting the received data

Demodulation and Modulation

Modulation Formats	COFDM(DVB-T)
Carriers	2K
Bandwidth	Configurable from 1MHz to 8MHz, step by 1KHz
FEC	1/2, 2/3, 3/4, 5/6, 7/8
Guard interval	1/32, 1/16, 1/8, 1/4
Constellation	QPSK, 16QAM, 64QAM
Bitrates	0.5Mbps to 31.67Mbps

RF Received

Frequency Bands	160MHz~860MHz
Tuning Step size	1KHz
Sensitivity	-97±1dBm(BW=8MHz, QPSK, CR=2/3, GI=1/16) for one channel and add 3dBm for two channel

RF Transmitted

Frequency Bands	200MHz~2300MHz(other bands can be supported with special manufacturing)
Tuning Step size	1KHz
Power out	Configurable, maximum -5dBm(subject to frequency)

Monitoring and control
Comprehensive setup with our Config Panel or other device via control uart. With our SconA or SconC config panel, the following parameters can be setup:
– Received frequency(f1) and bandwidth(b1)
– Transmitted frequency(f2), bandwidth(b2), fec, guard interval, constellation and transmission power

Temperature range
Full specification: 0° to +70°C Ambient
Storage: –40° to +80°C

Power requirements
Input range: 7~24VDC
Power consumption: <250mA@12V

Physical Characteristics
Dimensions: 73x51x15mm (not including connectors out of the board)

Application Block