10W full duplex wireless transceiver for video and data Link

• 10W full duplex wireless transceiver for video and data Link

   — TDD OFDM full duplex wireless transceiver for video and data Link
    — Up to 30Mbps Iperf Throughput @20MHz channel
    — Supports Point-to-Point and Point-to-Multipoint Networks
    — Interface through web browser or control uart
    — 2 Ethernet and 3 channel RS232 data link
    — Audio in/out supported by inside Audio codec
    — Long distance wireless transceiver with 10W RF power

SDL550 was designed for video and data wireless transmission with two way wireless data link. This OFDM radio device works at 800MHz or 1.4GHz bands, with frequency hopping technology (FHSS) to make sure better stability signal communication.

Features:

• TDD OFDM modulation
• Supports 806~826HMz band or 1428~1448MHz band
• Supports FHSS inside each band
• 1.4/3/5/10/20MHz band widths
• Max 30Mbps@20MHz throughput
• RF transmission power: 10W
• Constellation: QPSK, 16QAM, 64QAM, self-adaption
• Sensitivity: -108dBm(1Mbps)
• Supports IP data transmission(2 Ethernet port)
• Supports serial data transmission(3 channel, RS232)
• 1~15km(ground-to-ground), 30~150km(UAV-to-ground, optional distance grade)
• Web UI or control uart for management
• AES128 encryption
• Uplink and downlink stream control
• Networking mode: Point-to-Point, Point-to-Multipoint, Relay, and Mesh(specify)
• Movement Speed: Supports no less than 120km/h
• Compact size and light weight
• Rugged aluminum alloy housing
• Power input: 24~30V
• Power consumption<40W(RF Power 10W)
• Dimensions: 124*67.8*28.5mm
• Weight: 252g

I/O

I/O	Description
Ethernet1	4PIN ZH1.5mm connector, bridged with Ethernet2
Ethernet2	RJ45 connector, bridged with Ethernet1
RS232*3	9PIN ZH1.5mm connector, 3 channel RS232 uart
Audio in/out	4PIN ZH1.5mm connector, audio in and audio out port
Power-in	XT30PW-M connector
ANT1	Tx/Rx Antenna port, SMA female
ANT2	Rx Antenna port, SMA female

Wireless networking with SDL550

SDL550 supports two operating modes: Access Node or Central Node. It can be managed through web UI or Control uart. SDL550 supports features of maximum 16 Access Nodes connected to a Central Node. All of the Nodes are in a same wireless LAN and share the whole transmission bandwidth (maximum 30Mbps@20MHz throughput). Data from Central Node to Access Node, we call downlink, and data from Access Node to Central Node, we call uplink. Uplink and downlink stream ratio can be controlled through web UI or Control uart. When using SDL550 for Point-to-Point transmitting, uplink and downlink share the whole transmission bandwidth (maximum 30Mbps@20MHz throughput) too. SDL550 supports networking mode: Point -to-Point, Point-to-Multipoint, Relay, and Mesh (specify mesh version when order).

Point-to-Point transmitting

Point-to-Multipoint transmitting

Relay transmitting

Mesh transmitting (Specify)