PA1400/PA800 para Módulo DLM/DLB

Este PA1400(ou PA800) amplificador é um amplificador de potência linear de 2W, designed for using with DLM/DLB module

Características:

• Banda de frequência: 1425MHz-1455MHz(PA1400), 800MHz-830MHz(PA800)
• RF em: DLM(or DLB) module RF out(25±2dBm)
• Potência de saída de RF: 2W(33dBm)
• PA1400 Tx gain: 11dB, when used with DLM(or DLB) Módulo, set up the maximum RF power of DLM as 22~24 dBm, then the RF out power will be 33~35dbm.
• PA800 Tx gain: 13dB, when used with DLM(or DLB) Módulo, set up the maximum RF power of DLM as 20~22 dBm, then the RF out power will be 33~35dbm.
• Energia em: DC12V~16V
• Consumo de energia: <6Média W
• PCBA size: 46.5*31milímetros, thickness of PCB: 1.2milímetros
• Impedância: 50 ohm

Working together with DLM(or DLB) Módulo:

E/S

Energia em	Two bonding pads, should be soldered to connect with power VDD and GND.
Controlar	Two bonding pads, should be soldered to connect with DLM(or DLB) Switch signal pad(SCL e GND). A entrada alta(1.8V a 3,3 V) will drive the amplifier and work in Tx mode. The input low will enable the PA module to work in Rx mode.
RF em	IPEX connector for connection with main antenna of DLM(or DLB) módulo.
Saída de RF	Bonding pad, should be soldered to an antenna connector.

Housing case and assemble

PA1400/PA800 is just an OEM PCBA module. When you use this PA to work with DLM(or DLB) módulo, you should make metal housing case for your device, and a separated chamber must be designed for PA board. And also, it should keep at least 6mm space between the PA board and the upper cover. The back side of the PA board should be assembled to the metal directly and tightly to help heat dissipation and enable electrical grounding connection. For optimal performance it is important to include adequate heat dissipation strategies that incorporate a heat sink or fan into any designs that integrate the PA OEM module.