为什么COFDM发射机上电前需要连接天线

我们的很多客户都会问:

“Can I power on the COFDM transmitter without connecting an antenna?”

The short answer: No — doing so can permanently damage your transmitter.

This article explains why connecting an antenna is essential and how to avoid costly mistakes.

---

1. What Happens Inside a COFDM Transmitter?

一个 COFDM发射器 generates RF (无线电频率) energy that must be released into the air. The antenna is not just an accessory; 这是一个 necessary load for the transmitter.

Think of it like a water pump:

• With the pipe (天线) 打开, 水 (RF energy) flows freely.
• With the pipe blocked (no antenna), pressure builds up and damages the pump (transmitter’s power amplifier).

---

2. Why Powering On Without an Antenna Is Dangerous

When a transmitter is powered on without an antenna:

1. The RF energy has nowhere to go.
2. It reflects back into the transmitter.
3. The internal RF power amplifier absorbs the reflected energy.
4. The amplifier overheats and can burn out permanently.

This can happen within seconds.

---

3. Technical Explanation: VSWR and Reflected Power

In RF engineering terms:

• VSWR (电压驻波比) measures how much RF power is reflected back.
• A proper antenna ensures low VSWR, allowing most power to radiate.
• No antenna = very high VSWR → stress on the power amplifier → possible failure.

---

4. How to Prevent Damage

To protect your transmitter:

✅ Always connect the antenna before powering on.
✅ Make sure the antenna matches the correct frequency.
✅ For bench testing without actual transmission, use a proper RF dummy load.
❌ Never power on the transmitter with no antenna attached.

---

5. Signs Your Transmitter May Be Damaged

Even if the transmitter powers on, damage may have occurred if it was used without an antenna:

• Output power is much lower than expected.
• Short transmission range.
• Intermittent or no signal to the receiver.

If you notice these signs, the internal RF amplifier may need repair or replacement.

---

6. 图表: How RF Energy Flows

[发射机] --RF Energy--> [天线] --> Radiated to Air
       |
       |  (No Antenna)
       v
   Reflected Energy --> Burns Amplifier

A simple visual helps customers understand why the antenna is crucial.

---

7. 常问问题

---

8. Final Reminder

The antenna is an essential part of the COFDM RF system. Always connect it before switching on the transmitter.

A simple precaution can save you from expensive repairs and downtime.