Tần số liên kết dữ liệu từ xa Drone FPV Radio được tùy chỉnh

Tần số liên kết dữ liệu từ xa Drone FPV Radio được tùy chỉnh

It is suitable to develop a drone data transmission module with a different frequency. The unique personal customized frequencies can avoid the busy Microhard data transmission range 902~928Mhz

Giới thiệu

This is a newly launched digital transmission module, which is a small module with strong anti-interference ability. The device uses digitized signals through source coding and channel coding, transmits through digital channels, or stores them through digital storage and recording devices.

Lợi thế

1. Strong digital communication confidentiality
2. Khả năng chống nhiễu mạnh mẽ
3. Long transmission distance and good stability
4. With relatively low transmission delay, real-time transmission can be achieved
5. Can be directly connected and controlled through mobile phones or tablets, easy to install and use

Đặc điểm kỹ thuật

Definition of serial port

Indicator light description

Blue Light: Send Light After the connection is successful, the blue indicator light is always on, indicating that the data is being sent

Green Light: After the connection is successful, the green indicator light is always on, indicating that the data is being received

Red Light: The power-on indicator stays on after the power-on

Ghi chú: Phải lắp ăng-ten trước khi bật nguồn, and then powered on

Product Installation Instructions

Hướng dẫn cài đặt

1. For the transmitter, install the antenna before powering it on, nếu không thì, it will cause circuit damage.
2. Please ensure that the power supply voltage of the transmitter and receiver is within the specified voltage range, otherwise the circuit will be damaged.
3. Try to make the transmitter antenna vertically upwards and obscure it by obstacles to avoid shortening the communication distance due to blocking.
4. The antenna of the transmitter and receiver should be as far away as possible from the conductive parts.
5. Be sure to use the specified model of the antenna to ensure that the frequency band, trở kháng, và các thông số khác phù hợp.
6. Pay attention to keeping a suitable distance between the electronic equipment during installation, to minimize the electromagnetic interference between the equipment.

Usage Guidelines

2. Please ensure that all cables are securely fastened and that the connections are correct.
3. The power cord and serial port cable of the air terminal and the ground terminal are connected to the equipment
4. 12Nguồn điện V
5. Open the serial port tool page, identify the serial slogan, select the baud rate of 57600, and click to open
6. After turning on, the red light and the blue light are on, indicating that the connection is successful
7. After the connection is successful, the data can be sent

PCBA Layout

USB Driver

CP210x-Driver for Vcan2061.rar