Drone FPV Radio Telemetry Data Link frequency customized

Drone FPV Radio Telemetry Data Link frequency customized

It is suitable to develop a drone data transmission module with a different frequency. The unique personal customized frequencies can avoid the busy Microhard data transmission range 902~928Mhz

Introduzione

This is a newly launched digital transmission module, which is a small module with strong anti-interference ability. The device uses digitized signals through source coding and channel coding, transmits through digital channels, or stores them through digital storage and recording devices.

Vantaggio

1. Strong digital communication confidentiality
2. Forte capacità anti-interferenza
3. Long transmission distance and good stability
4. With relatively low transmission delay, real-time transmission can be achieved
5. Can be directly connected and controlled through mobile phones or tablets, easy to install and use

Specifica

Definition of serial port

Indicator light description

Blue Light: Send Light After the connection is successful, the blue indicator light is always on, indicating that the data is being sent

Luce verde: After the connection is successful, the green indicator light is always on, indicating that the data is being received

Luce rossa: The power-on indicator stays on after the power-on

Nota: L'antenna deve essere installata prima dell'accensione, and then powered on

Product Installation Instructions

Guida all'installazione

1. For the transmitter, install the antenna before powering it on, Altrimenti, it will cause circuit damage.
2. Please ensure that the power supply voltage of the transmitter and receiver is within the specified voltage range, otherwise the circuit will be damaged.
3. Try to make the transmitter antenna vertically upwards and obscure it by obstacles to avoid shortening the communication distance due to blocking.
4. The antenna of the transmitter and receiver should be as far away as possible from the conductive parts.
5. Be sure to use the specified model of the antenna to ensure that the frequency band, impedenza, and other parameters match.
6. Pay attention to keeping a suitable distance between the electronic equipment during installation, to minimize the electromagnetic interference between the equipment.

Usage Guidelines

2. Please ensure that all cables are securely fastened and that the connections are correct.
3. The power cord and serial port cable of the air terminal and the ground terminal are connected to the equipment
4. 12Alimentazione V
5. Open the serial port tool page, identify the serial slogan, select the baud rate of 57600, and click to open
6. After turning on, the red light and the blue light are on, indicating that the connection is successful
7. After the connection is successful, the data can be sent

PCBA Layout

USB Driver

CP210x-Driver for Vcan2061.rar