Convertitore da CVBS a IP, Scheda encoder di ingresso AV più piccola per uscita Ethernet, audio video composito, o trasformazione da telecamera a IP
Convertitore da CVBS a IP, Scheda encoder di ingresso AV più piccola per uscita Ethernet, audio video composito, o trasformazione da telecamera a IP
Sommario
Funzione
CVBS to IP converter AV encoding board function:
Analog audio and video input, H264 codifica, output through the network port IP ethernet.
Composite CVBS video to IP ethernet converter encoder board
mini Video Encoder Board CVBS input and IP Ethernet output
Support UDP RTSP player VLC
Analogue camera to internet ONVIF TCP IP
Richiesta gratuita, Preventivo gratuito, Supporto gratuito, Mostra demo di esempio gratuita .
Interfaccia
Convertitore da CVBS a IP Refer to the figure above for the encoding module interface and interface signals. The interface description is as follows:
- audio analogico e l'interfaccia di ingresso video: support analog video input, and audio input(line in Way)。
- Input signal interface(1.25mm spacer) e 13 PIN Toshiba FPC Cable socket multiplexing;
- porta di rete: 4PIN 1.25mm spacing base, the base signal, e il13 PIN Toshiba FPC Cable Socket multiplexing;
- Software protocol: UDP way output.
13Pin Toshiba FPC Pin Define
Nell'uso reale, you can put off the expansion interface card on the right side of the mini AV board to meet the needs of the structure.
interfaccia USB: Write board firmware, the 4Pin 1.25mm spacing seat can be removed when the structure is installed.
Matching serial port:
4Pin 1.25mm spacing seat, which can connect to our parameter configuration panel board to configure the H264 encoding code rate and other parameters. For details, please refer to the operation description of our parameter configuration panel.
After you change the parameters well, you do not need to change and adapt to the needs of the structure, you can remove the 4-pin seat.
grado di distanza opzionale: 2-pin welding hole, support input voltage range 6 ~ 15V.
CVBS to IP converter board size: 42x37x1.2mm.
The thickness of the board PCB is 1.2mm, the thickness of the maximum device on the back is less than 2mm, and the thickness of the highest front device on the front is less than 5.5mm.
Heating:
The maximum power consumption of the Convertitore da CVBS a IP encoding module is 150mA@12V.
The normal operating temperature range is 0 ℃ ~ 55 ℃ (degrees Celsius).
If it is placed in a small structure for operation for a long time, the CPU needs to be cooled.
Domande frequenti
1. Does it support my low-resolution thermal camera 256x192 on CVBS video?
- CVBS currently only supports the common AMICO (720x576) e NTSC (720x480) resolutions.
- Because the interface chip automatically adapts, We guess that our encoder board can not recognize your interface chip with this resolution.
- It is recommended that you connect the thermal imaging camera to an AV monitor or HDMI monitor to see if it can be displayed. If so, although the actual resolution is low, the video stream format may not be this 256x192.
- If it's HDMI, it's possible to modify the software to adapt to your camera; if it's CVBS, I think it's difficult unless you send the camera over and we can debug the software.
- If you need a suitable IR thermal imaging camera, please check our product.
Prodotti correlati
Modulo TX RX
Trasmettitore video analogico FPV Modulo audio video CVBS mittente 400-900 MHz UHF vcan1904
Il prezzo originale era: $50.00.$15.00Il prezzo attuale è: $15.00.
Codificatore da HDMI a IP
$399.00
