Come testare l'uscita PA su un collegamento wireless bidirezionale

In our two-way wireless link system TX900, the output power is automatically adjusted based on transmission distance. If you need to test the PA (Amplificatore di potenza) potenza in uscita, the automatic adjustment must be temporarily disabled, and long-range mode enabled. This guide provides a safe, step-by-step procedure.

Fare un passo 1: Stop the Wireless Modem

Before making any changes, stop the modem to prepare for configuration:

AT+CFUN=0  

Fare un passo 2: Enable QPSK Single-Antenna Long-Range Mode

Activate the long-range test mode to fix the output power for accurate measurement: （The TX900 purchased by the customer operates at 800 MHz, and the shipped 800 MHz units are configured with a 2 W transmit power using the specific set parameter 19. Perciò, this naming corresponds to that configuration. Per altre frequenze, please confirm with us first.）

AT^DSONCTX=1,8160,5,"19",0,0,0  

Fare un passo 3: Start the Wireless Modem

Restart the modem to apply the changes:

AT+CFUN=1  

Fare un passo 4: Measure the Spectrum

Perform spectrum measurements on ANT1. Make sure your measurement equipment is correctly connected and calibrated.

Fare un passo 5: Restore Normal Operation

After testing, return the modem to normal operation by executing:

AT+CFUN=0              // Stop the modem  
AT^DSONCTX=0           // Disable long-range test mode  
AT+CFUN=1              // Start the modem in normal mode  

Important Safety Precautions

• Only trained engineers should perform this procedure.
• Improper testing may damage the device. Any damage requires repair in China.
• Double-check all commands and connections before executing.

Seguendo questi passaggi, you can safely test PA output on a two-way wireless link while ensuring the device returns to normal operation afterward.

Posta relativa

1. More AT commands for two-way wireless link TX900
2. user manual for wireless video data transceiver TX900