Руководство по настройке приемника COFDM и протоколу потоковой передачи

Руководство по настройке приемника COFDM и протоколу потоковой передачи для vcan1776-RX.

я. Preparation

1. Download the upgrade firmware of COFDM receiver, which is support three firmware for three different streaming protocol. Download Here.
2. После обновления прошивки, the receiver will restore factory default parameters:
   • Центральная частота: 320 МГц
   • Wireless Bandwidth: 6 МГц
   • Ethernet Port IP Address: 192.168.0.215
   • Please use the LCD parameter configuration board to adjust the center frequency and bandwidth so that they match the transmitter’s saved settings.
3. Customers can access the receiver’s web server interface to modify:
   • The receiver’s own IP address. (Local IP)
   • The Windows PC IP address that the receiver will connect to. (Удаленный IP)Примечания:
     а) Удаленный IP refers to your Windows PC IP. Configure it according to your actual setup.
     б) Порт refers to the UDP streaming port, по умолчанию 1234.
     с) After making changes, restart the receiver for the settings to take effect.
4. Select the required Ethernet output protocol.

---

II. Обзор протокола

1. Rvl Protocol

Rvl is a custom protocol used between the COFDM transmitter and receiver. It streams video directly over UDP. The PC can only decode and play this stream using Сплейер.

а) Splayer Configuration

Примечания:

1. Обеспечить Порт установлено на 1234, consistent with the web server settings.
2. Configure the Codec according to the video stream type. Например, for H.264 low-latency video, use the corresponding codec settings.

б) После настройки, click the “Confirm” button to save the settings. Then press the play button (bottom left). The Windows PC will begin decoding and playing the UDP stream immediately upon receiving it.

---

2. RTSP Protocol

RTSP streaming is supported and can be played using VLC, EasyPlayer, and other RTSP-capable players.

а) The RTSP streaming URL can be found on the receiver’s web server RTSP page.

б) In EasyPlayer, simply enter the corresponding RTSP URL to start streaming.

---

3. MPEG-TS Protocol

MPEG-TS is a standard TS protocol streamed over UDP. The PC can decode and play the stream using VLC or similar players.

а) In VLC, enter the corresponding URL and click “Play”. The Windows PC will begin decoding and displaying the UDP stream immediately.