COFDM रिसीवर कॉन्फ़िगरेशन और स्ट्रीमिंग प्रोटोकॉल गाइड

vcan1776-RX के लिए COFDM रिसीवर कॉन्फ़िगरेशन और स्ट्रीमिंग प्रोटोकॉल गाइड.

मैं. Preparation

1. Download the upgrade firmware of COFDM receiver, which is support three firmware for three different streaming protocol. Download Here.
2. After upgrading the firmware, the receiver will restore factory default parameters:
   • केंद्र आवृत्ति: 320 मेगाहर्ट्ज
   • Wireless Bandwidth: 6 मेगाहर्ट्ज
   • Ethernet Port IP Address: 192.168.0.215
   • Please use the LCD parameter configuration board to adjust the center frequency and bandwidth so that they match the transmitter’s saved settings.
3. Customers can access the receiver’s web server interface to modify:
   • The receiver’s own IP address. (Local IP)
   • The Windows PC IP address that the receiver will connect to. (Remote IP)टिप्पणियाँ:
     ए) Remote IP refers to your Windows PC IP. Configure it according to your actual setup.
     बी) Port refers to the UDP streaming port, गलती करना 1234.
     सी) After making changes, restart the receiver for the settings to take effect.
4. Select the required Ethernet output protocol.

---

द्वितीय. प्रोटोकॉल अवलोकन

1. Rvl Protocol

Rvl is a custom protocol used between the COFDM transmitter and receiver. It streams video directly over UDP. The PC can only decode and play this stream using Splayer.

ए) Splayer Configuration

टिप्पणियाँ:

1. सुनिश्चित करें Port इसके लिए सेट है 1234, consistent with the web server settings.
2. Configure the कोडेक according to the video stream type. उदाहरण के लिए, for H.264 low-latency video, use the corresponding codec settings.

बी) कॉन्फ़िगरेशन के बाद, click the “Confirm” button to save the settings. Then press the play button (तली छोड़ें). The Windows PC will begin decoding and playing the UDP stream immediately upon receiving it.

---

2. RTSP Protocol

RTSP streaming is supported and can be played using वीएलसी, ईज़ीप्लेयर, and other RTSP-capable players.

ए) The RTSP streaming URL can be found on the receiver’s web server RTSP page.

बी) In EasyPlayer, simply enter the corresponding RTSP URL to start streaming.

---

3. MPEG-TS Protocol

MPEG-TS is a standard TS protocol streamed over UDP. The PC can decode and play the stream using वीएलसी or similar players.

ए) In VLC, enter the corresponding URL and click “Play”. The Windows PC will begin decoding and displaying the UDP stream immediately.