Mengapa 1681 Pertunjukan -20 dBm dalam Mode Debug Bahkan Saat Diatur ke 5 dBm

Mengapa 1681 Pertunjukan -20 dBm dalam Mode Debug Bahkan Saat Diatur ke 5 dBm

Customer feedback issues

When operating the 1681 wireless transmission module, some users may encounter a situation where the transmit power is configured as 5 dBm in the web interface, yet the Debug page displays a value around -20 dBm.

This behavior is expected and is directly related to how the 1681 manages transmit power under real operating conditions.

---

1681 Operating as an Access Node

In this setup, itu 1681 is working as an simpul akses at the air unit. (it also can set a central node at ground unit).

For access nodes, the transmit output power is adaptive rather than fixed. The system dynamically adjusts the output power based on distance and link quality.

---

How Adaptive Transmit Power Works

Itu 1681 uses adaptive power control to optimize wireless performance and system stability:

• Short distance / strong link
  When the receiver is close and the signal quality is high, itu 1681 will automatically reduce its transmit power.
  Sebagai akibat, the real-time value shown in the Debug interface may be as low as -20 dBm.
• Interlokal / weaker link
  As the distance increases or the wireless link becomes weaker, the system will gradually increase the transmit power to maintain a reliable connection.

This adaptive mechanism helps reduce unnecessary RF interference, lowers noise, and improves overall network efficiency.

---

Web Configuration vs. Actual Output Power

It is important to distinguish between configuration settings and real-time measurements:

• Transmit power setting on the web page (misalnya. 5 dBm)
  This value defines the maximum output power limit allowed by the system.
• Transmit power shown in Debug mode
  This reflects the sebenarnya, real-time transmit output power, which varies automatically according to link conditions.

Karena itu, setting the transmit power to 5 dBm does bukan mean the 1681 will always transmit at 5 dBm.
It only sets the upper boundary that the adaptive power control can reach when higher power is required.

---

You can also verify this behavior through practical testing.
If you move the devices several offices apart, or perform a corridor / cross-floor (run-through-building) test, you will observe that the transmit output power increases automatically.

Untuk bi-directional UAV communication modules, when operating at jarak yang lebih jauh or in environments with obstacles such as walls, floors, atau bangunan, the link quality degrades.
In these scenarios, the system will automatically raise the transmit power to compensate for the weaker signal and maintain a stable connection.

This dynamic power adjustment is specifically designed to support poor signal conditions, NLOS environments, dan long-range drone applications, ensuring reliable communication without requiring manual power changes.

---

Kesimpulan

If the Debug interface of your 1681 modul shows approximately -20 dBm while the transmit power is set to 5 dBm, this does not indicate a malfunction.

• Itu 1681 access node uses adaptive transmit power control
• Output power is reduced at short distances
• Mengirimkan kekuatan increases automatically as distance grows
• The web setting acts as a maximum limit, not a constant output value

This design ensures efficient, stabil, and interference-aware wireless communication.