COFDM Wireless Video Receiver HDMI cvbs output mini modulator module RX long distance fpv uav

COFDM Wireless Video Receiver HDMI CVBS output

COFDM Wireless Video Receiver HDMI CVBS output mini modulator module long-distance fpv UAV Transmission UART config Recorder

Spezifikation

Work for COFDM-907T

HD digital wireless video transmission receiver COFDM-907R
Built-in Decoder board and COFDM dual-antenna receiving demodulation module, the whole machine adopts aluminum alloy casing, high receiving sensitivity, low decoding display delay, high-definition video output stable and clear.

Eigenschaften

1. Dual Antenna reception
2. Support working frequency range: 160MHz ~ 930 MHz, the center working frequency can be configured;
3. Wireless bandwidth is configurable;
4. The sensitivity of dual antenna reception -100±1dbm (QPSK 8 MHz);
5. Wireless receiving status information (such as received signal strength, air interface rate, Datenrate, Arbeitsfrequenz, drahtlose Bandbreite, usw.) can be superimposed/not displayed on the video screen through the OSD switch button, or output to the serial port (individuell angepasst) ;
6. Low-latency H264 video decoding, support 1080P@60 decoding playback;
7. Audio and video output (HDMI, CVBS, USB port simultaneous output):
   1. HDMI Type-A port audio and video output
   2. CVBS (Lotus Head) AV-Audio- und Videoausgang
   3. Output video stream to the phone/tablet decoding display via USB port
8. Support video receiving and decrypting function (matching with video encryption at the transmitting end);
9. Support TF card or USB disk video recording;
10. Provide one-way single-direction transparent data transmission serial port;
11. Provide parameters to configure the serial port for working settings (such as center working frequency, drahtlose Bandbreite, receiving decryption password);
12. Energieversorgung: 6~15V, working power consumption is 230mA@12V.
13. Machine size: 115x90x34mm
14. Machine weight: 243 grams

Stecker:

1. Einschalten: 12~24V
2. RJ45：preset for future
3. HDMI-Ausgang: A type HDMI carrier, high-definition audio and video output interface
4. CVBS AV-Ausgang analog video output interface
5. RF ANT In wireless signal input antenna interface, SMA external threaded inner hole
6. UART : TX RX GND to connect the PC for frequency adjust
7. USB Schnittstelle:
   1. Recording video can be connected to an external USB flash drive or USB hard disk
   2. Upgrade for new firmware
8. Auto: Auto-Search new channel
9. Info: Show current channel information, Zum Beispiel, frequency, bandwidth, usw
10. REC: Record current channel to the USB stick
11. Stoppen: Stop to record
12. Channel Switch: Switch channel loop from 503Mhz, 509Mhz, 515Mhz, and 521Mhz.
13. OK: confirmation

Größe

112mm × 67.5mm × 22mm

RF Performance Test

Operating Center Frequency 470MHz, Power Amplifier: 1W

Operating Center Frequency 700MHz, Power Amplifier: 1W