IP mesh radio transceiver module for drone video data link UHF
IP mesh radio transceiver module is suitable for point-to-multi-point or multi-point-to-multi-point network requirements.
உதாரணமாக, your project requires multiple transmitters and multiple receivers. Each node can act as a relay for other nodes. Each node cannot be individually defined as a transmitter, ரிசீவர், or repeater. Each node is a transmitter, a receiver, and a repeater. Such as security squads, bicycle racing, 2+ drones in the sky and 2+ receivers on the ground, and other applications.
பொருளடக்கம்
வசதிகள்
- Two-way bidirectional transmission video data download and upload
- TDD OFDM full-duplex IP Mesh radio wireless transceiver module for video and data transmission
- Dual RF Power: 24±1dBm, 2-சேனல்
- Optional Working Frequency: 566~678MHz (112Mhz range hopping), 1420~1530MHz (110Mhz range hopping)
- Three Ethernet RJ45 for video or data and One RS232 UART data link, control UART (TTL) துறைமுக
- Support transmit distance: 500~2000 meters (தரை-நிலம்), 5~22km (UAV-க்கு-தரையில்); For a longer range, we needed the extra power amplifier support. (2வாட், 5வாட், 10வாட்)
- This board supports the CX6779K modem.
FHSS Frequency Hopping
- We designed this wireless video and data transmission with uplink and downlink for those who need the frequency automatic hopping function.
- With frequency hopping technology (FHSS) to ensure better stable signal communication, when the current frequency signal is worse, the system will automatically change the working frequency to another frequency for a better signal.
- This bidirectional OFDM radio module can work from 566Mhz to 678MHz or from 1420Mhz to 1530MHz bandwidth. So the frequency range has 110Mhz bandwidth change or hopping. If you set the frequency bandwidth at 10 மெகா ஹெர்ட்ஸ், then there are 11 frequency points for hopping.
விவரக்குறிப்பு
- TDD OFDM மாடுலேஷன் (Need FDD COFDM model?)
- ஆதரவுகள் 2 Frequency ranges (566~678MHz/1420~1530MHz)
- Supports FHSS frequency automatic hopping function
- 4/3/5/10/20/40MHz அலைவரிசைகள்
- Max 100Mbps throughput
- Dual RF transmission power: 24±1dBm, 2-channel for uplink and downlink
- விண்மீன்: க்யுபிஎஸ்கே, 16க்யுஏஎம்மில், 64க்யுஏஎம்மில், சுய தழுவல்
- உணர்திறன்: -95dBm (20மெகா ஹெர்ட்ஸ் அலைவரிசையை)
- Supports IP Video Data Transmission (3 ஈதர்நெட் போர்ட்)
- தொடர் தரவு பரிமாற்றத்தை ஆதரிக்கிறது (1எக்ஸ் ஆர்எஸ் 232, 1X TTL)
- Without extra PA, Up to 22km LOS (UAV-க்கு-தரையில்) and 2km LOS(தரை-நிலம்)
- Can add 2watts, 5வாட், அல்லது 10 watts to support longer range
- Web UI and control UART for management
- விருப்ப தூர தரம்
- விருப்ப தூர தரம் (Video stream needs more and data streaming needs less)
- நெட்வொர்க்கிங் முறை: One-to-one P2P, one-to-many P2MP, many-to-one MP2P, relay/repeater, mesh or swarm network。
- மின் நுகர்வு: <7டபிள்யூ
- பரிமாணங்கள்: 80 எக்ஸ் 57 x 9.1mm
- எடை: 41கிராம்
- Working Temperate: -20℃ ~ +65℃
- Storage Temperate: -40℃ ~ +80℃
IP Radio Module Connector (உள்ளீடு / வெளியீடு)
பவர் இன் | 2PIN PH2.0mmConnector, DC in:9விருப்ப தூர தரம் |
ஈதர்நெட்-1 | 4PIN PH1.25mm Connector |
ஈதர்நெட்-2 | 4PIN PH1.25mm Connector |
Ethernet-3 | 4PIN PH1.25mm Connector |
தரவு UART | 3PIN PH1.25mm Connector, RS232 மற்றும்(or TTL 3.3V) |
UART ஐக் கட்டுப்படுத்தவும் | 3PIN PH1.25mm Connector, டிடிஎல் 3.3 வி |
USB | Micro USB Connector, for software upgrading |
சொடுக்கி | Tx/Rx control signal for outside power amplifier |
Main-Antenna | விருப்ப தூர தரம், IPEX |
Second-Antenna | விருப்ப தூர தரம், IPEX |
12வி அவுட் | On-board 12V out(<200mA வில்), for cool fan power supply |
விருப்ப தூர தரம், Ethernet2 and Ethernet3
The three Ethernet ports on board are bridged connections, so their IP addresses are the same. The photo below shows the 4PIN signals of the Ethernet port.
Switch Port
This port is a TX transmitter / RX receiver control signal for the extra power amplifier. The maximum RF transmission power of our module is 24±1dBm two channels, We also provide the correct power amplifier to increase the RF Power to 2-watt / 5-watt /10-watt if you need a longer range than 22km.
The below diagram shows how to add a power amplifier outside extra of this IP Radio Module.
This operation is for your reference only. If you need to add an external power amplifier, it is best to tell us and we will configure it for you, or ask a professional to operate it, இல்லையெனில், the PA will be easily burned.
சிக்னல் | Electrical level | விருப்ப தூர தரம் | விளக்கம் | mark |
PA-enable1 | 1.8வி | தி | High electrical level: data transmitting, change to high electrical level at 3.19us before transmitting and to low electrical level at 0.26us after transmitting finished. | High-Tx
Low-Rx |
தரவு UART
- The data UART is RS232 as default.
- We also can change the data port from RS232 to TTL 3.3V UART before the cargo delivery.
- The baud rate of data UART can be set as 115200, 57600, 38400, 19200, 9600, 4800, 2400, மற்றும் 1200.
Control UART and USB port
Only one of these two ports is valid at the same time. Control UART is valid by default shipment. Please contact us if you need to use a USB UART. You can manage our module with Web UI or AT command via control UART.
LEDs light
LED1: பவர் LED, சிவப்பு, light on normal powered.
LED2: blue, LED3: பச்சை, LED2 and LED3 indicate the wireless working status as described in the below table.
Central node | Blue LED2 light on all the time and green LED3 is not light |
Access node | Green LED3 light on all the time when the access node is connected with the central node. |
The blue LED2 indicate the access node linking signal status with the central node.
When the wireless linking signal is strong, blue LED2 blinks every 30 விநாடிகள்; When the wireless linking signal is middle, blue LED2 blinks every 6 விநாடிகள்; When the wireless linking signal is weak, blue LED2 blinks every 1 இரண்டாவது. |
Sometimes customers may need to assemble the indicating LEDs on their housing case panel, so our board also provides a soldering hole for the three LED signals. The LED signal is described in the below table.
LED | விளக்கம் | Representation soldering hole |
LED1 | பவர் LED | LED1-GND and LEDs-VCC |
LED2 | Wireless indicating LED | LED2-GND and LEDs-VCC |
LED3 | LED3-GND and LEDs-VCC |
Wireless networking with the IP MESH Radio Module
- Our module supports two operating modes: SMA பெண். It can be managed through Web UI or AT command via control UART.
- Our module supports features of a maximum of 63 SMA பெண். All the Nodes are in the same wireless LAN and share the whole transmission bandwidth (maximum 100Mbps throughout).
- Data from the Central Node to the Access Node, SMA பெண், and data from the Access Node to the Central Node, SMA பெண்.
- வலை UI அல்லது AT கட்டளை மூலம் அப்லிங்க் மற்றும் டவுன்லிங்க் ஸ்ட்ரீம் விகிதத்தைக் கட்டுப்படுத்தலாம்.
- When using Our module for Point-to-Point transmitting, uplink மற்றும் downlink முழு பரிமாற்ற அலைவரிசையை பகிர்ந்து (maximum 100Mbps throughout) கூட.
- Our module supports networking modes: விருப்ப தூர தரம், Point-to-Multi-point, விருப்ப தூர தரம், விருப்ப தூர தரம் (specify mesh version when ordering).
விமர்சனங்கள்
எந்த மதிப்பீடுகளும் இன்னும் உள்ளன.