UAV drone video data link module wireless video transmitter and receiver for camera two-way long-range TDD transceiver lightweight
Преглед садржаја
UAV drone video data link Advantage
- Мале величине 7.2X4.8X1cm, лагана (less than 60 грама), 2X5-watt PA dimension
- long-range. Тхе omnidirectional fiberglass antenna can reach 30 км. The directional antenna can reach 50КМ
- Истовремено, има 2 bidirectional RS232 serial ports, which are convenient for uploading and uploading data.
- The minimum delay can reach 28ms (not including the camera recording and monitor displaying time)
- 20ms excluding monitor and camera. 1080н 60 about 80ms
- Користећи TDD-OFDM transmission protocol, long-range, a large amount of data, free networking, стабилан и издржљив.
- Using wide temperature components, it can work normally from -40 degrees to 85 степени
- ИП 67 protection can be used in harsh outdoor environments for a long time.
- Compared with ordinary bridges, the distance is 10 times that of ordinary WIFI transmission protocols.
- Multiple power supply redundancy designs, high reliability.
- They are specifically optimized for video streaming.
Апликација
- Main purpose: Cooperate with IP cameras to transmit video data over long-range.
- Security monitoring: such as agricultural monitoring, industrial monitoring, factory warehouse monitoring, water monitoring, превенција шумскиһ пожара, mountain monitoring, итд.
- Internet of Things: Ad hoc network data transmission.
- UAV Drones: imagery, пренос података.
- Special industry: power station, очување вода, итд.
- Public security and armed police firefighting: miniaturized image transmission can be customized. На пример, multiple ad hoc network cameras.
Спецификација
- Радна фреквенција: Уобичајено 1.4Г или 2.3Г (2310-2380Mhz)band
- Уграђени 2 * 1В Појачало снаге
- Напајање: 7-18в
Connector Input Output
Дефинисати:
If the light is not on, it means that the wireless video data transmission has a problem, maybe the working power is too small, or the power amplifier is damaged.
јачина сигнала | LED P2 | LED P3 | LED P4 |
> -70 | always | always | always |
-71 до -75 | always | always | -75 |
-75 до -80 | ван | always | always |
-80 до -83 | на | -80 | и |
-83 до -88 | always | ван | ван |
less than -88 | flash | ван | ван |
нема сигнала | marquee |
5, Data Serial Port, 1.25mm connector, 232 level. (some motherboards only have serial port 1, no serial port 2)
serial number | функција |
1 | ГНД |
2 | 5В излаз |
3 | Serial 2 РКС |
4 | Serial 2 ТКС |
5 | Serial 1 РКС |
6 | Serial 1 ТКС |
6, 26Pin LNA 0.5mm FPC flexible cable connector, defined as follows:
serial number | функција | note |
1 | 5в | излаз |
2 | 5в | излаз |
3 | НЦ | |
4 | RF1 | RF1 Switch |
5 | RF2 | RF2 Switch |
6 | ANTD | Antenna Switch |
7 | НЦ | |
8 | НЦ | |
9 | РЕСЕТОВАЊЕ | MESH firmware reset |
10 | LNA2_LED | |
11 | LNA1_LED | |
12 | ГНД | |
13 | 12в | 12В улаз |
14 | 12в | 12В улаз |
15 | ГНД | |
16 | RSSI_H | Received Signal Strength Indicator: Strong |
17 | RSSI_M | Received Signal Strength Indicator: Medium |
18 | RSSI_L | Received Signal Strength Indicator: Weak |
19 | ANTC | Antenna Switch on/off |
20 | PA1 | Појачало 1 Свитцх |
21 | изборна оцена удаљености | антена 1 Свитцх |
22 | LAN1_TX_N | Network Port |
23 | LNA1_TX_P | Network Port |
24 | ГНД | |
25 | LNA1_RX_N | Network Port |
26 | LNA1_RX_P | Network Port |
7, Улазна снага: 7-18в, the positive and negative poles are prohibited to be reversed! Иначе, it will be damaged
Please directly weld the wire or weld the XT30 connector. The connector is also marked with positive and negative poles, don’t reverse it!
8, Onboard Pin Network Port:
Pin spacing 1.27mm, 4ПИН- (This network port can only configure the data of the local device and the other party, and cannot access the data of LAN6 and LAN9)
9, 20ПИН- 0.5mm FPC flexible cable connector, the definition is as follows: (provided later)
10, ЛАН порт:
1.25mm connector, If it is often plugged and unplugged, it is recommended to externally connect the RJ45 socket with an isolation transformer.
- LAN-RX-P
- LAN-RX-N
- LAN-TX-P
- LAN-TX-N
11, ЛАН порт: 12PIN interface, PCI-E, and USB interface
12, Fan Interface: GND is ground, 5V outputs 5V, VCC is connected to the main power supply, and the connector is 78172 series
13, Jumper switch:
1. Turn it to the ON position to turn off the RF1 amplifier power.
2. Turn it to the ON position and turn off the power of the RF2 amplifier.
3, not used.
4. Restore the factory settings.
After powering on and entering the system, dial the code to 1 for more than 5 секунде, and then dial the code to 0 to restore the factory settings.
Parameter Configuration Tool for Windows Software Download
ФАКс
да, this wireless video data link module supports point and one-point to multi-points. Considering the bandwidth and transmission speed, our engineer suggests connecting up to four points at the same time.
Хвала.
I will take a test video to show you the exact ways and real latency of the two-way wireless video data audio link module.
1.4G has stock.
The engineer told me that he can modify the frequency from 1.4G to 2.3G (2310-2380Mhz), can not 2.4G now.
питање: Can you make it the working frequency at 2280-2380Mhz?
Извињавам се, no we don't have it at 2280-2380Mhz, only 2310-2380Mhz.
- Support RJ45 IP Ethernet (IP camera or computer)
- Support Rs-232 data port. (shell printed COM, 5, Data Serial Port, 1.25mm connector, 232 level.
- Support 10Mbps
- 2x1W PA support 10~30km
2x2w PA support 30~50km - 2x1W 7.2X4.8X1cm (72x48x10mm) less than 60 грама
- Only 1.4G now, not support 2.1G or 4.8G as working frequency.
- OK.Support as relay to extend long-range.
- The device between the transmitter and receiver needs to be configured as the master, and the other two as slaves.
Проверите испод слике.