UAV drone video data link module wireless video transmitter and receiver for camera two-way long-range TDD transceiver lightweight
مواد جو جدول
UAV drone video data link Advantage
- سائيز ۾ ننڍو 7.2X4.8X1cm, هلڪو (less than 60 گرام), 2X5-watt PA dimension
- long-range. جي omnidirectional fiberglass antenna can reach 30 ڪلو ميٽر. The directional antenna can reach 50ايم
- ساڳئي وقت ۾, ان وٽ آهي 2 bidirectional RS232 serial ports, which are convenient for uploading and uploading data.
- The minimum delay can reach 28ms (not including the camera recording and monitor displaying time)
- 20ms excluding monitor and camera. 1080منصوبابندي 60 about 80ms
- استعمال ڪندي TDD-OFDM transmission protocol, long-range, a large amount of data, free networking, مستحڪم ۽ پائيدار.
- Using wide temperature components, it can work normally from -40 degrees to 85 درجا
- IP67 protection can be used in harsh outdoor environments for a long time.
- Compared with ordinary bridges, the distance is 10 times that of ordinary WIFI transmission protocols.
- Multiple power supply redundancy designs, اعلي اعتبار.
- They are specifically optimized for video streaming.
درخواست
- Main purpose: Cooperate with IP cameras to transmit video data over long-range.
- Security monitoring: such as agricultural monitoring, industrial monitoring, factory warehouse monitoring, water monitoring, forest fire prevention, mountain monitoring, وغيره.
- Internet of Things: Ad hoc network data transmission.
- UAV Drones: imagery, ڊيٽا جي منتقلي.
- Special industry: power station, پاڻي جي بچاءُ, وغيره.
- Public security and armed police firefighting: miniaturized image transmission can be customized. مثال طور, multiple ad hoc network cameras.
Specification
- ڪم ات: ھونئن 1.4ز يا 2.3ز (2310-2380Mhz)band
- بلڊ اندر 2 * 1W پاور امپليفائر
- بجلي جي فراهمي: 7-18هلي
Connector Input Output
وصف:
If the light is not on, it means that the wireless video data transmission has a problem, maybe the working power is too small, or the power amplifier is damaged.
سگنل جي طاقت | LED P2 | LED P3 | LED P4 |
> -70 | always | always | always |
-71 جي طرف -75 | always | always | -75 |
-75 جي طرف -80 | بند | always | always |
-80 جي طرف -83 | تي | -80 | ۽ |
-83 جي طرف -88 | always | بند | بند |
less than -88 | flash | بند | بند |
ڪو اشارو | marquee |
5, ڊيٽا سيريل پورٽ, 1.25mm connector, 232 level. (some motherboards only have serial port 1, no serial port 2)
serial number | فعل |
1 | GND |
2 | 5V ٻا output |
3 | Serial 2 RX |
4 | Serial 2 موڪليو ' |
5 | Serial 1 RX |
6 | Serial 1 موڪليو ' |
6, 26Pin LNA 0.5mm FPC flexible cable connector, defined as follows:
serial number | فعل | note |
1 | 5هلي | پيداوار |
2 | 5هلي | پيداوار |
3 | مهندرا | |
4 | RF1 | RF1 Switch |
5 | RF2 | RF2 Switch |
6 | ANTD | Antenna Switch |
7 | مهندرا | |
8 | مهندرا | |
9 | ري سيٽ ڪريو | MESH firmware reset |
10 | LNA2_LED | |
11 | LNA1_LED | |
12 | GND | |
13 | 12هلي | 12ٿيل پٽ |
14 | 12هلي | 12ٿيل پٽ |
15 | GND | |
16 | RSSI_H | Received Signal Strength Indicator: Strong |
17 | RSSI_M | Received Signal Strength Indicator: Medium |
18 | RSSI_L | Received Signal Strength Indicator: Weak |
19 | ANTC | Antenna Switch on/off |
20 | PA1 | بجلي ايمپلي 1 سوئچ |
21 | ANT1 | Antenna 1 سوئچ |
22 | LAN1_TX_N | نيٽ ورڪ پورٽ |
23 | LNA1_TX_P | نيٽ ورڪ پورٽ |
24 | GND | |
25 | LNA1_RX_N | نيٽ ورڪ پورٽ |
26 | LNA1_RX_P | نيٽ ورڪ پورٽ |
7, بجلي داخل ٿيل: 7-18هلي, the positive and negative poles are prohibited to be reversed! ٻي صورت ۾, it will be damaged
Please directly weld the wire or weld the XT30 connector. The connector is also marked with positive and negative poles, don’t reverse it!
8, Onboard Pin Network Port:
Pin spacing 1.27mm, 4پن (This network port can only configure the data of the local device and the other party, and cannot access the data of LAN6 and LAN9)
9, 20پن 0.5mm FPC flexible cable connector, the definition is as follows: (provided later)
10, LAN پورٽ:
1.25mm connector, If it is often plugged and unplugged, it is recommended to externally connect the RJ45 socket with an isolation transformer.
- LAN-RX-P
- LAN-RX-N
- LAN-TX-P
- LAN-TX-N
11, LAN پورٽ: 12PIN interface, PCI-E, and USB interface
12, Fan Interface: GND is ground, 5V outputs 5V, VCC is connected to the main power supply, and the connector is 78172 سلسلو
13, Jumper switch:
1. Turn it to the ON position to turn off the RF1 amplifier power.
2. ان کي ON پوزيشن ڏانھن ڦيرايو ۽ RF2 ايمپليفائر جي طاقت کي بند ڪريو.
3, استعمال نه ڪيو ويو.
4. فيڪٽري سيٽنگون بحال ڪريو.
پاور آن ڪرڻ ۽ سسٽم ۾ داخل ٿيڻ کان پوء, ڏانهن ڪوڊ ڊائل ڪريو 1 کان وڌيڪ لاء 5 سيڪنڊ, ۽ پوء ڪوڊ ڊائل ڪريو 0 فيڪٽري سيٽنگون بحال ڪرڻ لاء.
Parameter Configuration Tool for Windows Software Download
FAQs
ها, هي وائرليس وڊيو ڊيٽا لنڪ ماڊل پوائنٽ ۽ ون پوائنٽ کان ملٽي پوائنٽس کي سپورٽ ڪري ٿو. بينڊوڊٿ ۽ ٽرانسميشن جي رفتار تي غور ڪندي, اسان جو انجنيئر هڪ ئي وقت چار پوائنٽس تائين ڳنڍڻ جو مشورو ڏئي ٿو.
مهرباني.
مان توهان کي ٻه طرفي وائرليس وڊيو ڊيٽا آڊيو لنڪ ماڊل جا صحيح طريقا ۽ حقيقي ويڪرائي ڏيکارڻ لاءِ هڪ ٽيسٽ وڊيو وٺندس.
1.4G وٽ اسٽاڪ آهي.
انجنيئر مون کي ٻڌايو ته هو 1.4G کان 2.3G (2310-2380Mhz) جي تعدد کي تبديل ڪري سگهي ٿو, هاڻي 2.4G نٿو ڪري سگهان.
سوال: ڇا توھان ان کي 2280-2380Mhz تي ڪم ڪندڙ تعدد ڪري سگھو ٿا?
افسوس, no we don't have it at 2280-2380Mhz, صرف 2310-2380Mhz.
- سپورٽ RJ45 IP Ethernet (IP ڪئميرا يا ڪمپيوٽر)
- سپورٽ Rs-232 ڊيٽا پورٽ. (شيل پرنٽ ٿيل COM, 5, ڊيٽا سيريل پورٽ, 1.25mm connector, 232 level.
- سپورٽ 10Mbps
- 2x1W PA سپورٽ 10 ~ 30km
2x2w PA سپورٽ 30 ~ 50km - 2x1W 7.2X4.8X1cm (72x48x10mm) less than 60 گرام
- صرف 1.4G هاڻي, ڪم ڪندڙ تعدد جي طور تي 2.1G يا 4.8G کي سپورٽ نٿو ڪري.
- OK.Support رلي طور ڊگھي حد تائين وڌائڻ لاء.
- ٽرانسميٽر ۽ رسيور جي وچ ۾ ڊوائيس ماسٽر جي طور تي ترتيب ڏيڻ جي ضرورت آهي, ۽ ٻيا ٻه غلام وانگر.
مهرباني ڪري هيٺ ڏنل تصوير چيڪ ڪريو.