Uart-configuratiepanelen

All COFDM modules(of het nu gaat om zendermodules of ontvangermodules) can have their parameters configured through the uart port. These parameters include modulation setup, werkfrequentie, bandbreedte, transmitted gain, H264 code rate, encryption and decryption password, uart baud rate, enz. provides three models of uart config panel for different applications and cases, named SconA, SconB, and SconC.
　

Uart config panel	SCONA	SconB	SconC
tonen	0.96 inch OLED	8 digit 8-segments LED	1.54 inch OLED
Dimensies	54*23.4mm	85*50*22mm	65*31mm
Keys	3	4	3
Supported modules	All COFDM modules
Stroomvoorziening	Powered from COFDM module(5V)
Connection interface	Uart signal with VDD, 4 PIN PH1.25 connector or USB connector or just 4 solder holes
Parameters configurable	allemaal	parts of	allemaal

SCONA

The SconA config panel has a 0.96-inch OLED display, met 3 operation buttons. SconA config panel dimensions: 54*23.4mm, it does not include the connectors out of the board edge. For different COFDM modules and device case designs, it should use one of the three connecting interfaces:

• 4 PIN PH1.25 connector(TTL uart)， use this one to connect the module with TTL control UART.
• USB connector(RS232 uart), use this one to connect the module with the RS232 control UART in the USB connector.
• 4 PIN holes(RS232 uart), use this one to connect the module with RS232 control UART for compact device case design.

SconB

The SconB config panel has an 8-digit 8-segments LED display, met 4 operation buttons. SconB config panel is installed in a plastic outer shell, with dimensions 85*50*22mm. For different COFDM modules, it should use one of the two connecting interfaces:

• 4 PIN PH1.25 connector(CFG2, TTL uart)， use this one to connect the module with TTL control UART.
• USB connector(CFG1, RS232 uart), use this one to connect the module with the RS232 control UART in the USB connector.

　

SconC

The SconC config panel has a 1.54-inch OLED display, met 3 operation buttons. SconC config panel dimensions: 65*31mm, it does not include the connectors out of the board edge. For different COFDM modules and device case designs, it should use one of the three connecting interfaces:

• 4 PIN PH1.25 connector(TTL uart)， use this one to connect the module with TTL control UART.
• USB connector(RS232 uart), use this one to connect the module with the RS232 control UART in the USB connector.
• 4 PIN holes(RS232 uart), use this one to connect the module with RS232 control UART for compact device case design.