UAV drone video data link module wireless video transmitter and receiver for camera two-way long-range TDD transceiver lightweight
Содржина
UAV drone video data link Advantage
- Мали по големина 7.2X4.8X1cm, лесен (less than 60 грама), 2X5-watt PA dimension
- long-range. на omnidirectional fiberglass antenna can reach 30 км. The directional antenna can reach 50КМ
- Во исто време, тоа има 2 bidirectional RS232 serial ports, which are convenient for uploading and uploading data.
- The minimum delay can reach 28ms (not including the camera recording and monitor displaying time)
- 20ms excluding monitor and camera. 1080P 60 about 80ms
- Користење на TDD-OFDM transmission protocol, long-range, a large amount of data, free networking, стабилни и трајни.
- Using wide temperature components, it can work normally from -40 degrees to 85 степени
- IP67 protection can be used in harsh outdoor environments for a long time.
- Compared with ordinary bridges, the distance is 10 times that of ordinary WIFI transmission protocols.
- Multiple power supply redundancy designs, high reliability.
- They are specifically optimized for video streaming.
апликација
- Main purpose: Cooperate with IP cameras to transmit video data over long-range.
- Security monitoring: such as agricultural monitoring, industrial monitoring, factory warehouse monitoring, water monitoring, спречување на шумски пожари, mountain monitoring, итн.
- Internet of Things: Ad hoc network data transmission.
- UAV Drones: imagery, пренос на податоци.
- Special industry: power station, заштеда на вода, итн.
- Public security and armed police firefighting: miniaturized image transmission can be customized. на пример, multiple ad hoc network cameras.
спецификација
- Работна фреквенција: стандардно 1.4G или 2.3G (2310-2380Mhz)band
- Вграден 2 * 1W засилувач на моќност
- Напојување: 7-18V
Connector Input Output
Дефинирај:
If the light is not on, it means that the wireless video data transmission has a problem, maybe the working power is too small, or the power amplifier is damaged.
Јачина на сигнал | LED P2 | LED P3 | LED P4 |
> -70 | always | always | always |
-71 до -75 | always | always | -75 |
-75 до -80 | исклучување | always | always |
-80 до -83 | на | -80 | и |
-83 до -88 | always | исклучување | исклучување |
less than -88 | flash | исклучување | исклучување |
нема сигнал | marquee |
5, Сериска порта за податоци, 1.25mm connector, 232 level. (some motherboards only have serial port 1, no serial port 2)
serial number | функција |
1 | GND |
2 | 5V излез |
3 | Serial 2 RX |
4 | Serial 2 Соединетите Американски Држави |
5 | Serial 1 RX |
6 | Serial 1 Соединетите Американски Држави |
6, 26Pin LNA 0.5mm FPC flexible cable connector, defined as follows:
serial number | функција | Забелешка |
1 | 5V | излез |
2 | 5V | излез |
3 | NC | |
4 | RF1 | RF1 Switch |
5 | RF2 | RF2 Switch |
6 | ANTD | Antenna Switch |
7 | NC | |
8 | NC | |
9 | РЕСЕТИРАЈ | MESH firmware reset |
10 | LNA2_LED | |
11 | LNA1_LED | |
12 | GND | |
13 | 12V | 12V input |
14 | 12V | 12V input |
15 | GND | |
16 | RSSI_H | Received Signal Strength Indicator: Strong |
17 | RSSI_M | Received Signal Strength Indicator: Medium |
18 | RSSI_L | Received Signal Strength Indicator: Weak |
19 | ANTC | Antenna Switch on/off |
20 | PA1 | засилувач 1 Прекинувач |
21 | опционална оценка за растојание | антена 1 Прекинувач |
22 | LAN1_TX_N | Мрежна порта |
23 | LNA1_TX_P | Мрежна порта |
24 | GND | |
25 | LNA1_RX_N | Мрежна порта |
26 | LNA1_RX_P | Мрежна порта |
7, моќност: 7-18V, the positive and negative poles are prohibited to be reversed! Во спротивно,, it will be damaged
Please directly weld the wire or weld the XT30 connector. The connector is also marked with positive and negative poles, don’t reverse it!
8, Onboard Pin Network Port:
Pin spacing 1.27mm, 4PIN (This network port can only configure the data of the local device and the other party, and cannot access the data of LAN6 and LAN9)
9, 20PIN 0.5mm FPC flexible cable connector, the definition is as follows: (provided later)
10, LAN порта:
1.25mm connector, If it is often plugged and unplugged, it is recommended to externally connect the RJ45 socket with an isolation transformer.
- LAN-RX-P
- LAN-RX-N
- LAN-TX-P
- LAN-TX-N
11, LAN порта: 12PIN interface, PCI-E, and USB interface
12, Fan Interface: GND is ground, 5V outputs 5V, VCC is connected to the main power supply, and the connector is 78172 серија
13, Jumper switch:
1. Turn it to the ON position to turn off the RF1 amplifier power.
2. Turn it to the ON position and turn off the power of the RF2 amplifier.
3, not used.
4. Restore the factory settings.
After powering on and entering the system, dial the code to 1 for more than 5 секунди, and then dial the code to 0 to restore the factory settings.
Parameter Configuration Tool for Windows Software Download
Најчесто поставувани прашања
Да, this wireless video data link module supports point and one-point to multi-points. Considering the bandwidth and transmission speed, our engineer suggests connecting up to four points at the same time.
благодарение.
I will take a test video to show you the exact ways and real latency of the two-way wireless video data audio link module.
1.4G has stock.
The engineer told me that he can modify the frequency from 1.4G to 2.3G (2310-2380Mhz), can not 2.4G now.
прашање: Can you make it the working frequency at 2280-2380Mhz?
Извинете, no we don't have it at 2280-2380Mhz, only 2310-2380Mhz.
- Support RJ45 IP Ethernet (IP camera or computer)
- Support Rs-232 data port. (shell printed COM, 5, Сериска порта за податоци, 1.25mm connector, 232 level.
- Support 10Mbps
- 2x1W PA support 10~30km
2x2w PA support 30~50km - 2x1W 7.2X4.8X1cm (72x48x10mm) less than 60 грама
- Only 1.4G now, not support 2.1G or 4.8G as working frequency.
- OK.Support as relay to extend long-range.
- The device between the transmitter and receiver needs to be configured as the master, and the other two as slaves.
Ве молиме, проверете ја сликата подолу.