COFDM Relay Repeater
ໂມດູນ COFDM Relay Repeater ສໍາລັບ drone ເຄື່ອງສົ່ງວິດີໂອໄຮ້ສາຍ UAV ແລະເຄື່ອງຮັບ Vcan1870
ສາລະບານ
ການນໍາສະເຫນີ
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (e.g. 400Mhz) for communication with the relay, and a different frequency (e.g. 700Mhz) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
ຄຸນນະສົມບັດ
- Wireless Video COFDM Video Data demodulation and re-modulation
- Stable signal transfer in NLOS and high-speed moving (less than 600km/hour)
- ຄວາມຖີ່ຂອງການເຮັດວຽກທີ່ສາມາດປັບໄດ້, ວາງຂອງສັນຍານ, ພະລັງງານສົ່ງໄຟຟ້າ, ແລະອື່ນໆ (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 milliseconds
- Widely frequency range 200Mhz-3000Mhz
- ສະຫນັບສະຫນູນ @50I
- Bandwidth 1Mhz-8Mhz ທາງເລືອກ
- Video signal repeater for long-distance
ການນໍາສະເຫນີ
ຂໍ້ມູນ:
IO
ວັດສະດຸປ້ອນ RF | Two SMA females (to receive the signal) |
RF ຜົນຜະລິດ | SconB ຫຼື SconC (to send out the signal again) |
control UART | 4PIN PH1.25mm Connector |
ພະລັງງານໃນ | 2PIN PH2.54mm phenix Connector |
TF-card | For firmware update |
Power led | red LED, constant light when the device is normally powered |
Link led | green led, blinks on transmitting the received data |
Demodulation and Modulation
ຮູບແບບໂມດູນ | COFDM(DVB-T) |
ຜູ້ໃຫ້ບໍລິການ | 2K |
Bandwidth | ຕົວເຊື່ອມຕໍ່ XT30PW-M, ຕົວເຊື່ອມຕໍ່ XT30PW-M |
FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
ໄລຍະຫ່າງກອງ | 1/32, 1/16, 1/8, 1/4 |
constellation | QPSK, 16QAM, 64QAM |
ອັດຕາບິດ | 0.5ຕົວເຊື່ອມຕໍ່ XT30PW-M |
RF Received
ແຖບຄວາມຖີ່ | 160860MHz MHz ~ (need an extra down converter block for 860-2300Mhz) |
ການປັບຂະໜາດຂັ້ນຕອນ | 1KHz |
ທີ່ລະອຽດອ່ອນ | -97±1dBm(BW=8MHz, QPSK, CR=2/3, GI=1/16) for one channel and add 3dBm for two-channel |
RF Transmitted
ແຖບຄວາມຖີ່ | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
ການປັບຂະໜາດຂັ້ນຕອນ | 1KHz |
Power out | Configurable, maximum -5dBm(subject to frequency) |
ການຕິດຕາມແລະການຄວບຄຸມ
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) and bandwidth (B1)
– TX Transmitted frequency (F2), ວາງຂອງສັນຍານ (B2), FEC, ໄລຍະຫ່າງກອງ, constellation, and transmission power
ລະດັບອຸນຫະພູມ
@50I: 0° to +70°C Ambient
ການເກັບຮັກສາ: @50I
ຄວາມຕ້ອງການພະລັງງານ
@50I: 7~24VDC
ການນໍາໃຊ້ພະລັງງານ: <250mA@12V
ລັກສະນະທາງກາຍະພາບ
ຂະຫນາດ: 73x51x15mm
ນ້ໍາຫນັກລວມ: 32.4 ກໍາ
UART AT commands
The AT commands mainly used in the COFDM Wireless Relay Repeater are ATDR, ATSD, ATGD, ATSR, ATGR, and ATGB. For the introduction of specific commands, see the document.
FAQs
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
The below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.