UAV drone video data link module wireless video transmitter and receiver for camera two-way long-range TDD transceiver lightweight
目錄
UAV drone video data link Advantage
- 體積細 7.2X4.8X1cm, 輕 (less than 60 克), 2X5-watt PA dimension
- 遠程. 的 omnidirectional fiberglass antenna can reach 30 公里. The directional antenna can reach 50公里
- 同時, 它有 2 bidirectional RS232 serial ports, which are convenient for uploading and uploading data.
- The minimum delay can reach 28ms (not including the camera recording and monitor displaying time)
- 20ms excluding monitor and camera. 1080p 60 about 80ms
- 用 TDD-OFDM transmission protocol, 遠程, a large amount of data, free networking, stable and durable.
- Using wide temperature components, it can work normally from -40 degrees to 85 度
- IP67 protection can be used in harsh outdoor environments for a long time.
- Compared with ordinary bridges, the distance is 10 times that of ordinary WIFI transmission protocols.
- Multiple power supply redundancy designs, high reliability.
- They are specifically optimized for video streaming.
應用
- Main purpose: Cooperate with IP cameras to transmit video data over long-range.
- Security monitoring: such as agricultural monitoring, industrial monitoring, factory warehouse monitoring, water monitoring, forest fire prevention, mountain monitoring, 等.
- Internet of Things: Ad hoc network data transmission.
- UAV Drones: imagery, 數據傳輸.
- Special industry: power station, 水利, 等.
- Public security and armed police firefighting: miniaturized image transmission can be customized. 例如, multiple ad hoc network cameras.
规范
- 工作頻率: 默認 1.4g 或者 2.3g (2310-2380Mhz )波段
- 內置。 2 * 1功率放大器
- 电源: 7-18V
Connector Input Output
定義:
如果燈唔光, 意味住無線視頻數據傳輸存在問題, 可能係工作功率太細, 或功率放大器損壞.
信號強度 | 發光二極管P2 | 發光二極管P3 | 發光二極管P4 |
> -70 | 總是 | 總是 | 總是 |
-71 自 -75 | 總是 | 總是 | -75 |
-75 自 -80 | 远离嘅 | 總是 | 總是 |
-80 自 -83 | 喺 | -80 | 同 |
-83 自 -88 | 總是 | 远离嘅 | 远离嘅 |
less than -88 | 閃光 | 远离嘅 | 远离嘅 |
冇信號 | 選取框 |
5, 數據串口, 1.25MM連接器, 232 水平. (有些主板只有串口 1, 無串口 2)
serial number | 功能 |
1 | 吉安达 |
2 | 5V輸出 |
3 | Serial 2 rx |
4 | Serial 2 Tx |
5 | Serial 1 rx |
6 | Serial 1 Tx |
6, 26Pin LNA 0.5mm FPC flexible cable connector, defined as follows:
serial number | 功能 | note |
1 | 5V | 輸出 |
2 | 5V | 输出 |
3 | 數控 | |
4 | 射頻1 | RF1 Switch |
5 | 射頻2 | RF2 Switch |
6 | ANTD | Antenna Switch |
7 | 數控 | |
8 | 數控 | |
9 | 重置 | MESH firmware reset |
10 | LNA2_LED | |
11 | LNA1_LED | |
12 | 吉安达 | |
13 | 12V | 12v 輸入 |
14 | 12V | 12v 輸入 |
15 | 吉安达 | |
16 | RSSI_H | 接收信號強度指示器: Strong |
17 | RSSI_M | 接收信號強度指示器: Medium |
18 | RSSI_L | 接收信號強度指示器: Weak |
19 | ANTC | Antenna Switch on/off |
20 | PA1 | 功率放大器 1 開關 |
21 | 螞蟻1 | 天线 1 開關 |
22 | LAN1_TX_N | Network Port |
23 | LNA1_TX_P | Network Port |
24 | 吉安达 | |
25 | LNA1_RX_N | Network Port |
26 | LNA1_RX_P | Network Port |
7, 電源輸入: 7-18V, the positive and negative poles are prohibited to be reversed! 否則, it will be damaged
Please directly weld the wire or weld the XT30 connector. The connector is also marked with positive and negative poles, don’t reverse it!
8, Onboard Pin Network Port:
Pin spacing 1.27mm, 4針 (This network port can only configure the data of the local device and the other party, and cannot access the data of LAN6 and LAN9)
9, 20針 0.5mm FPC flexible cable connector, the definition is as follows: (provided later)
10, LAN端口:
1.25MM連接器, If it is often plugged and unplugged, it is recommended to externally connect the RJ45 socket with an isolation transformer.
- LAN-RX-P
- LAN-RX-N
- LAN-TX-P
- LAN-TX-N
11, LAN端口: 12PIN interface, PCI-E, and USB interface
12, Fan Interface: GND is ground, 5V outputs 5V, VCC is connected to the main power supply, and the connector is 78172 series
13, Jumper switch:
1. Turn it to the ON position to turn off the RF1 amplifier power.
2. Turn it to the ON position and turn off the power of the RF2 amplifier.
3, not used.
4. Restore the factory settings.
After powering on and entering the system, dial the code to 1 for more than 5 秒, and then dial the code to 0 to restore the factory settings.
Parameter Configuration Tool for Windows Software Download
常見問題
系嘅, 該無線視頻數據鏈路糢塊支持啲同單點到多點. 考慮帶寬和傳輸速度, 我哋嘅工程師建議同時連接多達四個啲.
多谢。.
我將通過測試視頻向你展示雙向無線視頻數據音頻鏈路糢塊嘅確切方式同真實延遲.
1.4G有庫存.
工程師告訴我,他可以將頻率由1.4G修改為2.3G(2310-2380Mhz), 而家唔可以2.4G.
问题。: 你能把它的工作頻率設在2280-2380Mhz嗎?
唔好意思, no we don't have it at 2280-2380Mhz, 只有2310-2380Mhz.
- Support RJ45 IP Ethernet (IP camera or computer)
- Support Rs-232 data port. (shell printed COM, 5, 數據串口, 1.25MM連接器, 232 水平.
- Support 10Mbps
- 2x1W PA support 10~30km
2x2w PA support 30~50km - 2x1W 7.2X4.8X1cm (72x48x10mm) less than 60 克
- Only 1.4G now, not support 2.1G or 4.8G as working frequency.
- OK.Support as relay to extend long-range.
- The device between the transmitter and receiver needs to be configured as the master, and the other two as slaves.