Analog FPV Video Transmitter and Receiver AHD CVBS Camera input 100Mhz-3.3G frequency

Talateu

This is a newly launched analog video transmission module.
It is a module with a small size, maʻulalo ʻa e malohi, and simple frequency matching.
This product processes analog video signals with continuously changing time (including space) and amplitude as a source and channel to meet the needs of different scenarios.

Konga

1. Multiple receivers can receive video signals at the same time\
2. Lalo latency, wide frequency, maʻulalo ʻa e malohi, low heat generation
3. Stable transmission efficiency
4. Simple frequency matching
5. Lahi siʻisiʻi (TX: 48mm x 32mm) (RX: 38mm x 28mm), maʻulalo ʻa e malohi
6. For simple frequency change, the starting frequency can be set through the serial port, pea 'oku 'i ai e 4 frequency points can be cycled by pressing the button
7. High image quality and low signal interference rate

Fakapapau'i e

1. Transmitter frequency range 100Mhz-3500Mhz (3.5L)
2. Receiver frequency range 100Mhz-3500Mhz (3.5L)
3. Default frequency range 400-900Mhz
4. Default power amplifier: 3-uati
5. Power supply 5V (not input 12V)
6. Maʻuʻanga fakamatala ki he vitioó: AHD / CVBS camera
7. Frequency selection method: one button (four frequency preset loops chosen)

FAQ:

Q. Can you make the analog FPV transmitter and receiver have a relay/repeater?

HA: This is an analog model, there is no relay or repeater in the middle. If you need a relay or repeater for your FPV transmission system, please check the below model, which uses the COFDM digital transmission system, it can have a repeater. 3W PA 50KM