RF TX module COFDM transmitter 70Mhz 80Mhz 150Mhz 160Mhz

Does your RF TX module COFDM transmitter support operating down to 150 MHz or lower?

Now we have noted it supports 200 MHz~2300MHz. According to the description of the TX module datasheet, it is not recommended to operate below 200MHz. Let’s take the board and test it later to see if it works.

iVcan: Our engineer has tested the RF TX module COFDM transmitter pcba. The minimum or lowest frequency can reach 70Mhz, but our receiver minimum range of 160Mhz and up to 860Mhz.

If you set the TX module at 70Mhz, then an Up-conversion board is required.
The lower the frequency, the greater the transmission power.
A PA power amplifier of less than 200 megabytes will be larger.

munhu anoda kubetserwa: For the current request, the 160Mhz is good, so without an Up-converting board.
We use low power from the TX module and after we use our own PA, so it is not your question. We need an output of the Tx of about -10dBm.

iVcan: At 160MHz, the maximum output of the transmitter module is between -3dBm and -5dBm. Eheka, it can also be set to -10dBm through AT commands or the parameter board.

munhu anoda kubetserwa: -5dBm is good, Please test it at -5 dBm output of Tx module.

The waveform when output-5DBM is output during testing of TX module

Does your RF TX Module support 3.5G?

COFDM Vhidhiyo encoder modulator transmitter module 3.5G uye 4G bvunzo mhedzisiro.

Can you send us your COFDM TX RX module with metal casing and power amplifier inside?

Ehe, we can offer you the full set of COFDM TX RX modules with metal casing and power amplifier (1-watt PA, 2.5-watt PA, or 10-watt PA optional)R, and cofdm transmitter antenna and receiver antenna.