COFDM Relay Repeater
COFDM releja atkārtotāja modulis drona UAV bezvadu video raidītājam un uztvērējam Vcan1870
Satura rādītājs
ievads
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (piem. 400Mhz) for communication with the relay, and a different frequency (piem. 700Mhz) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
iezīme
- Wireless Video COFDM Video Data demodulation and re-modulation
- Stable signal transfer in NLOS and high-speed moving (less than 600km/hour)
- Regulējams darba biežums, joslas platums, pārraides jauda, utt (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 milisekundes
- Widely frequency range 200Mhz-3000Mhz
- atbalsts Frekvenču joslas
- joslas platums 1Mhz-8Mhz fakultatīvs
- Video signal repeater for long-distance
ievads
specifikācija:
IO
RF ievade | Two SMA females (to receive the signal) |
RF izeja | SconB vai SconC (to send out the signal again) |
control UART | 4PIN PH1.25mm Connector |
Bezvadu video raidītājs SDI kameras liela attāluma COFDM lejupsaites raidītājam | 2PIN PH2.54mm phenix Connector |
TF-card | For firmware update |
Power led | red LED, constant light when the device is normally powered |
Link led | green led, blinks on transmitting the received data |
Demodulation and Modulation
Modulation Formats | COFDM(DVB-T) |
Carriers | 2K |
joslas platums | Bezvadu video raidītājs SDI kameras liela attāluma COFDM lejupsaites raidītājam, Bezvadu video raidītājs SDI kameras liela attāluma COFDM lejupsaites raidītājam |
FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
Guard intervāls | 1/32, 1/16, 1/8, 1/4 |
zvaigznājs | QPSK, 16QAM, 64QAM |
Bitrates | 0.5Bezvadu video raidītājs SDI kameras liela attāluma COFDM lejupsaites raidītājam |
RF Received
Frekvenču joslas | 160MHz ~ 860MHz (need an extra down converter block for 860-2300Mhz) |
Tuning Step size | 1KHz |
Jutība | -97±1dBm(BW=8MHz, QPSK, CR=2/3, GI=1/16) for one channel and add 3dBm for two-channel |
RF Transmitted
Frekvenču joslas | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
Tuning Step size | 1KHz |
Power out | Configurable, maximum -5dBm(subject to frequency) |
Monitoring and control
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) and bandwidth (B1)
– TX Transmitted frequency (F2), joslas platums (B2), FEC, aizsargs intervāls, constellation, and transmission power
Temperatūras diapazons
Visaptveroša raidītāja iestatīšana ar Sihid Config Panel vai datoru vai citu ierīci, izmantojot Control UART: 0° to +70°C Ambient
glabāšana: Visaptveroša raidītāja iestatīšana ar Sihid Config Panel vai datoru vai citu ierīci, izmantojot Control UART
Jaudas prasības
Visaptveroša raidītāja iestatīšana ar Sihid Config Panel vai datoru vai citu ierīci, izmantojot Control UART: 7~24VDC
Elektrības patēriņš: <250mA@12V
Fiziskās īpašības
Izmēri: 73x51x15mm
Bruto svars: 32.4 grami
UART AT komandas
The AT commands mainly used in the COFDM Wireless Relay Repeater are ATDR, ATSD, ATGD, ATSR, ATGR, and ATGB. For the introduction of specific commands, see the document.
FAQ
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
Joprojām ir jautājums?
Lūdzu, sazinieties ar mums, lai iegūtu vairāk informācijas.
Nosūtiet savu jautājumuThe below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.