COFDM қабылдағышындағы OSD дисплей функциясы

key1: turn on/off the status of the OSD displaying, long press it to switch(more than 1s). the status will be kept after reboot. When the OSD status is on without any OSD data input from the data uart, the device will display information on the video screen as:

РФ：338.0МГц BW：4.0МГц; РФ, жұмыс жиілігі; BW, өткізу қабілеті

QPSK CR：2/3  GI:1/16; Constellation, FEC, Қорғау аралығы.

AIR：3.90Mbps; AIR, wireless transmitting bitrates

VBR：3.05Mbps AES OFF; VBR, video bitrates; AES OFF, AES encryption turned off.

SIG1：27   SIG2：22; SIG1, signal intensity of ant 1; SIG2, signal intensity of ant 2   

ber1:0.14%  ber2:100.00%; ber1, bit error rate of ant 1; ber2, bit error rate of ant 2

Бірде-Storage OFF REC; video recording status

What is VBR? VBR is the video encoding bit rate at the transmitter. Since the video picture changes dynamically, VBR is of course variable, but it fluctuates around the encoding bit rate set by the transmission system: 7.81*0.8=6.248Mbps

How to use OSD API in Our COFDM systems?

Steps description:

1) The customer’s module sends the digital data to our COFDM transmitter via UART;

2) Our transmitter will send the digital data with video data together to our COFDM receiver via the wireless link;

3) Our receiver will send out the digital data to the customer’s module via UART;

4) The customer’s module should transfer the digital data into the characters string they want to show on the video screen in OSD mode. Then the customer’s module sends the characters string to our receiver via the same UART.

5) Our receiver will display the character’s string on the HDMI display screen with the video together in OSD mode.

API of Our COFDM receiver:

command	ATOSD$(font), $(X),$(y),$(str) _example：ATOSD1,40,20,height: 100m_
параметрлері	font:  0:  8×16, пиксел;  1:  16×24, пиксел; X:   0 қарай 1919, horizontal axis; мен: 0 қарай 1079, vertical axis; Str:   characters string start to show on the HDMI screen from (X,y) point; space characters used for a clean screen at that point. Since ’_’ is the command end flag, No ’_’ can be used in these parameters.
функция	To display the characters string on the HDMI screen with the video in OSD mode
return	Null
сипаттамасы	1) This command is used for the customer’s MCU module to our Receiver via data UART; 2) You can use ATST command(described in other documents) to define our Receiver UART;  3) You should draw the HDMI screen following 1920*1080 pixels via (X,y) axis. Our receiver firmware will adjust it automatically according to the real screen systems.