UAV drone vidio isema ni isema module ni vidio isema ni vakauta kei na iciqoqo ni itaba ni TDD transceiver rua na sala vcan1401
$0.00
UAV drone video data link module wireless video transmitter and receiver for camera two-way long-range TDD transceiver lightweight
iTuvatuva ni Lewena
UAV drone video data link Advantage
- Lailai na kena levu 7.2X4.8X1cm, mamada (less than 60 i gram), 2X5-watt PA dimension
- long-range. Na omnidirectional fiberglass antenna can reach 30 kilomita. The directional antenna can reach 50KM
- Ena gauna vata o ya, e tiko kina 2 bidirectional RS232 serial ports, which are convenient for uploading and uploading data.
- The minimum delay can reach 28ms (not including the camera recording and monitor displaying time)
- 20ms excluding monitor and camera. 1080T 60 about 80ms
- Using TDD-OFDM transmission protocol, long-range, a large amount of data, free networking, vale ni manumanu ka kaukauwa.
- Using wide temperature components, it can work normally from -40 degrees to 85 ivakatagedegede
- IP67 protection can be used in harsh outdoor environments for a long time.
- Compared with ordinary bridges, the distance is 10 times that of ordinary WIFI transmission protocols.
- Multiple power supply redundancy designs, nuitaki cecere.
- They are specifically optimized for video streaming.
Ivolakerekere
- Main purpose: Cooperate with IP cameras to transmit video data over long-range.
- Security monitoring: such as agricultural monitoring, industrial monitoring, factory warehouse monitoring, water monitoring, forest fire prevention, mountain monitoring, kei na so tale.
- Internet of Things: Ad hoc network data transmission.
- UAV Drones: imagery, vakau itukutuku.
- Special industry: power station, tu vakawawa ni wai, kei na so tale.
- Public security and armed police firefighting: miniaturized image transmission can be customized. Me kena ivakaraitaki, multiple ad hoc network cameras.
Specification
- Cakacaka vakarauta na kena vagauna: Sega ni tiko 1.4LAKO se 2.3LAKO (2310-2380Mhz）band
- Tara cake ena 2 * 1W Power Amplifier
- Kakana ni kaukauwa: 7-18V
Connector Input Output
Vakamacalataka:
If the light is not on, it means that the wireless video data transmission has a problem, maybe the working power is too small, or the power amplifier is damaged.
| kaukauwa ni sikinala | LED P2 | LED P3 | LED P4 |
| > -70 | always | always | always |
| -71 me -75 | always | always | -75 |
| -75 me -80 | tani | always | always |
| -80 me -83 | ena | -80 | kei na |
| -83 me -88 | always | tani | tani |
| less than -88 | flash | tani | tani |
| sega na sikinala | marquee |
5, iVakatakilakila ni iTukutuku, 1.25mm connector, 232 level. (some motherboards only have serial port 1, no serial port 2)
| serial number | Cakacaka |
| 1 | GND |
| 2 | 5V output |
| 3 | Serial 2 RX |
| 4 | Serial 2 TX |
| 5 | Serial 1 RX |
| 6 | Serial 1 TX |
6, 26Pin LNA 0.5mm FPC flexible cable connector, defined as follows:
| serial number | itavi | me kilai |
| 1 | 5V | Output |
| 2 | 5V | veiqaravi |
| 3 | NC | |
| 4 | RF1 | RF1 Switch |
| 5 | RF2 | RF2 Switch |
| 6 | ANTD | Antenna Switch |
| 7 | NC | |
| 8 | NC | |
| 9 | VAKADABERI TALE | MESH firmware reset |
| 10 | LNA2_LED | |
| 11 | LNA1_LED | |
| 12 | GND | |
| 13 | 12V | 12Na icurucuru ni V |
| 14 | 12V | 12Na icurucuru ni V |
| 15 | GND | |
| 16 | RSSI_H | Received Signal Strength Indicator: Strong |
| 17 | RSSI_M | Received Signal Strength Indicator: Medium |
| 18 | RSSI_L | Received Signal Strength Indicator: Weak |
| 19 | ANTC | Antenna Switch on/off |
| 20 | PA1 | Amplifier ni kaukauwa 1 Veisau |
| 21 | ANT1 | Ivana ni walesi o 1 Veisau |
| 22 | LAN1_TX_N | Waqa ni Veisemati |
| 23 | LNA1_TX_P | Waqa ni Veisemati |
| 24 | GND | |
| 25 | LNA1_RX_N | Waqa ni Veisemati |
| 26 | LNA1_RX_P | Waqa ni Veisemati |
7, Na icurucuru ni kaukauwa: 7-18V, the positive and negative poles are prohibited to be reversed! Kevaka e sega, it will be damaged
Please directly weld the wire or weld the XT30 connector. The connector is also marked with positive and negative poles, don’t reverse it!
8, Onboard Pin Network Port:
Pin spacing 1.27mm, 4PIN (This network port can only configure the data of the local device and the other party, and cannot access the data of LAN6 and LAN9)
9, 20PIN 0.5mm FPC flexible cable connector, the definition is as follows: (provided later)
10, LAN waqa:
1.25mm connector, If it is often plugged and unplugged, it is recommended to externally connect the RJ45 socket with an isolation transformer.
- LAN-RX-P
- LAN-RX-N
- LAN-TX-P
- LAN-TX-N
11, LAN waqa: 12PIN interface, PCI-E, and USB interface
12, Fan Interface: GND is ground, 5V outputs 5V, VCC is connected to the main power supply, and the connector is 78172 isoqoni
13, Jumper switch:
1. Turn it to the ON position to turn off the RF1 amplifier power.
2. Turn it to the ON position and turn off the power of the RF2 amplifier.
3, not used.
4. Restore the factory settings.
After powering on and entering the system, dial the code to 1 for more than 5 na sekodi, and then dial the code to 0 to restore the factory settings.
Parameter Configuration Tool for Windows Software Download
YVT
Io, this wireless video data link module supports point and one-point to multi-points. Considering the bandwidth and transmission speed, our engineer suggests connecting up to four points at the same time.
Vakavinavinaka.
I will take a test video to show you the exact ways and real latency of the two-way wireless video data audio link module.
1.4G has stock.
The engineer told me that he can modify the frequency from 1.4G to 2.3G （2310-2380Mhz）, can not 2.4G now.
Taro: Can you make it the working frequency at 2280-2380Mhz?
Kere veivosoti, no we don't have it at 2280-2380Mhz, only 2310-2380Mhz.
- Support RJ45 IP Ethernet (IP camera or computer)
- Support Rs-232 data port. (shell printed COM, 5, iVakatakilakila ni iTukutuku, 1.25mm connector, 232 level.
- Support 10Mbps
- 2x1W PA support 10~30km
2x2w PA support 30~50km - 2x1W 7.2X4.8X1cm (72x48x10mm) less than 60 i gram
- Only 1.4G now, not support 2.1G or 4.8G as working frequency.
- OK.Support as relay to extend long-range.
- The device between the transmitter and receiver needs to be configured as the master, and the other two as slaves.
Yalovinaka dikeva na iyaloyalo e ra.
Dua tikoga na nomu taro?
Yalovinaka veitaratara mai me baleta na ikuri ni ivakamacala.
Vakauta Na Nomu Taro
| Bibi | N/A |
|---|---|
| Oi rau na gacagaca | N/A |
| Amplifier ni kaukauwa | 2 X 1 Watts, 2 X 5 Watts |
