What is the working range of your long-range VTX?

Without an extra Power Amplifier, our long-range VTX Vcan1681 has 300mW PA inside, it supports 0~15km. Plus 2-watt power amplifier, the transmission distance can reach 30km in the visual range. (our model is TX900 ) Plus 5-watt power amplifier, the transmission distance can reach 80km. Plus 10-watt power amplifier, the transmission distance can reach 150km.

Recently I encountered a problem visiting the air unit (transmitter) from the ground unit (receiver).

Everything works okay, but the problem is that it looks like it has locked me out from accessing the air unit via the ground unit. When I try to access the air unit by its IP address, it brings up that login screen. When I connect via ethernet, it works fine, but through the ground unit, it asks to log in. Two days ago everything was fine. Now I changed the side IP address and I can't even ping it anymore, but the link is still okay, and I can access it directly. Solution: Please clear your browser's cookie information and visit again and it should solve the problem. You should have used our devices with multiple versions of firmware. However, with the same IP address, the browser cached the cookies of different versions of the firmware, resulting in a confusing display. Clearing the cookies of the browser and visiting again should solve the problem. No need to restore the factory settings of our equipment, as you said.

Can I use the Ethernet2 port on tx900 as an input port?

Why I am asking, I had Raspberry PI connected to the Ethernet1 port and streaming video. Now I have the same unit connected to the Ethernet2 port, and I got nothing. I can see activity on that port but no video goes through on the other side. I can't even ping it video the Ethernet2. Are they bridged? Reply: The ethernet1 and the ethernet 2 are the two ports of the switch chip inside. The two network ports of Vcan1681 and TX900 bridge internally. They are equivalent to the network ports of a network switch. You need to check whether there is any problem with the 4PIN network port connection cable and whether there is any IP address conflict in the LAN (including our 1618 device). Each of our 1618s takes up two IP addresses. If you have not modified the IP address at the time of shipment, the default is 192.168.1.12 and 192.168.168.12, and the docked 1681 defaults to 192.168.1.11 and 192.168.168.11 Verification is also very simple. Connect eth1 and eth2 of the 1681 module to two PCs' network ports, and check if the PCs can communicate normally by pinging each other.) Maybe the RJ45 cable and the ethernet 2 do not closely contact the ethernet 2.

It showed the IP address in the management login section as the internal MCU address.

The 192.168.168.x network segment is Modem’s IP. The 192.168.1.x network segment is the IP of the MCU.

Is your long-range VTX video transmitter module possible to send data, voice over them?

Yes. There are two RJ45 ethernet interfaces for video or internet data, one set of audio interfaces, and three sets of data interfaces. If you transmit data, the data interface can be used rs232, TTL, sbus, etc. It can be modified according to your needs.

What about the software and firmware of the long-range VTX video transmitter module?

Just use your own software. We are equivalent to providing a wireless network, Connect two computers or network devices.

So does it work like a wave relay?

Yes, max Support 7 ~ 8 relays at one line. More details, https://ivcan.com/drone-repeater-solution/

How does the long-range VTX work?

I want to explain the working scenario of the long-range VTX. Two drones will be in the air with HD cameras and one modem will be on the ground connected to the display. The transceiver modem in the air will send videos from the air to the ground + some more useful information. They will also receive some camera control and PTT commands from the ground. Another transceiver modem on the ground will receive videos from the air and will display them on some LCD or send them on ethernet. It will also send camera control + PTT commands to drones in the air.

Best long-range VTX video transmitter module for drone robot

Tabula ohipa

Eaha te huru o to outou tere-maoro-raa?

Aita ana'e e matini uira hau, E 300mW PA i roto i ta tatou fare haapiiraa tua tahi, e turu te reira i te 0~15km.
Plus 2-watt power amplifier, e nehenehe te atearaa o te tere e tae i te 30km i ni'a i te hoho'a. (ta tatou hi'oraa TX900)
Plus 5-watt power amplifier, e tae'ahia te atearaa e 80km.
Plus 10-watt power amplifier, e nehenehe te atearaa e tae'ahia i te 150km.

Aita i maoro a'enei, ua farerei au i te hoê fifi i roto i te tereraa manureva (transmitter) no roto mai i te repo fenua (afata apo parau).

E tere maitai te mau mea atoa, te fifi râ, mai te mea ra e, ua opani te reira ia'u eiaha ia tomo i roto i te piha rereraa o te manureva na ni'a i te fenua. Ia tamata ana'e au i te tomo i roto i te piha manureva na ni'a i to'na vahi faaearaa, na te reira e afa'i mai i taua hoho'a ra. Ia tuati atu vau na roto i te ethernet, e mea maitai te reira, na roto râ i te repo, e ani oia ia tomo i roto. E piti mahana i ma'iri a'e nei, e mea maitai te mau mea atoa.
I teie nei, ua taui au i te vahi nohoraa e aita ta'u e nehenehe faahou e ha'uti i te reira, tera râ, te vai noa ra te tuatiraa, e e nehenehe ta'u e farii ti'a'tu i te reira.

Te rave'a:
A tumâ na i te haamaramaramaraa no ta outou faanahoraa no te Itenati e a hi'o faahou e na te reira e faaafaro i te fifi.
E mea ti'a ia outou ia faaohipa i ta tatou mau matini e te mau matini e rave rahi. Tera ra, e te hoê â vahi nohoraa, ua faanaho te faanahoraa no te Itenati i te mau tuhaa taa ê o te taiete, Te mau mana'o tauturu no te haapiiraa e te aporaa. E mea ti'a ia faaafaro i te fifi na roto i te tumâraa i te mau tuhaa o te faanahoraa no te Itenati e te haere-faahou-raa'tu e farerei. Aita e faufaa ia faaho'i faahou mai i te mau vairaa o ta tatou mau tauihaa, mai ta oe i parau.

E nehenehe anei ta ' u e faaohipa i te uahu Ethernet2 i nia i te tx900 ei uahu input?

No te aha vau e ani ai, Te vai ra ta'u te Raspberry PI i ni'a i te uahu no Ethernet1 e te hoho'a video. I teie nei, hoê â ta'u amuiraa i ni'a i te uahu no Ethernet2, e aita hoê mea i roaa ia'u. E nehenehe ta'u e ite i te ohipa i ni'a i taua uahu ra, aita râ e video e tere ra i te tahi atu pae. Aita ta'u e nehenehe e tape'a i te reira i ni'a i te itenati. Te feia e farii nei, a faaite mai.?

Pahonoraa: Te ethernet1 e te ethernet 2 o na uahu e piti ïa o te pahi e vai ra i roto.

Na uahu e piti o te Vcan1681 e te TX900. E tuea te reira i te mau uahu o te hoê pitopito o te pu haapurororaa.

E mea ti'a ia outou ia hi'opo'a e, te vai ra anei te tahi fifi i ni'a i te reni 4PIN no ni'a i te niuniu afa'ifa'i e te vai ra anei te tahi fifi i roto i te faanahoraa LAN (tae noa'tu i to tatou 1618 Te mau mana'o tauturu no te). I roto i te mau matahiti 1618, te vai ra e piti vahi nohoraa.

Mai te mea e, aita outou i taui i te vahi nohoraa i te taime haponoraa, te hape o te 192.168.1.12 e te 192.168.168.12, e te feia rave ohipa i roto i te ô 1681 Te mau Mana'o Tauturu no te 192.168.1.11 e te 192.168.168.11

E mea ohie roa atoa te hi'opoaraa. Faatu'ati i te 11 e te 2 o te 1681 Te mau mana'o tauturu no te tuatapaparaa e te haapiiraa’ oire no te natiraa, e a hi'o e, e nehenehe anei ta te mau taata e paraparau maitai na roto i te tauahiraa te tahi i te tahi.)

Peneia'e te niuniu RJ45 e te ethernet 2 eiaha e tapiri atu i te ethernet 2.

Ua faaite mai te reira i te vahi nohoraa IP i roto i te tuhaa no te faatereraa i te mau faufaa ei vahi nohoraa no roto mai i te MCU.

Te 192.168.168.x network, o te IP ïa no Modem.
Te tuhaa 192.168.1.x, o te IP ïa o te MCU.

E nehenehe anei ta outou e hapono i te mau haamaramaramaraa, te reo i ni'a ia ratou?

E.
Te vai nei e piti RJ45 ethernet interfaces no te video e aore râ internet data, hoê anairaa haruharuraa faaroo, e e toru pu'e parau haamaramaramaraa. Mai te mea e hapono outou i te mau haamaramaramaraa, e nehenehe te faanahoraa pu'e itepiri e faaohipahia rs232, TE MAU PARAU APÎ O TE EKALESIA, Te mau mana'o tauturu no te, te tahi atu a. E nehenehe te reira e tauihia ia au i to outou mau hinaaro.

Eaha ïa no ni'a i te faanahoraa roro uira e te mau matini roro uira no te mau hoho'a video VTX?

A faaohipa noa i ta outou iho matini roro uira.
Ua tuea noa tatou i te horoaraa i te hoê pu haapurororaa niuniu ore, Faatu'ati e piti matini roro uira e aore râ te pu'ereni.

E ohipa atoa te reira mai te hoê are miti ra te huru?

E, Te patururaa i te feia faatere o te Ekalesia 7 ~ 8 E ta'uma i ni'a i te hoê reni.
Tahi atu mau haamaramaramaraa, https://ivcan.com/drone-repeater-solution/
replay repeater for wireless video transmitter and receiver

Nahea te faanahoraa VTX e ohipa ai?

Te hinaaro nei au e faataa'tu i te ohipa i tupu i ni'a i te VTX.

E piti pata hoho'a i roto i te aore e te hoê pata hoho'a e hoê modem i nia i te repo tei taaihia i te faaiteiteraa.

E hapono te matini faataui mata'i i te mau ripene video mai roto mai i te reva i raro i te repo + te tahi mau haamaramaramaraa hau atu i te faufaa. E farii atoa ratou i te tahi mau pata hoho'a e te tahi mau hoho'a i ni'a i te repo.

E fana'o te tahi atu taata i nia i te repo i te mau ripene video no roto mai i te reva e e faaiteite oia i te reira i nia i te tahi LCD aore ra e hapono atu i nia i te ethernet. E hapono atoa mai te reira i te hi'opoaraa i te hoho'a + Te mau faaueraa a te PTT no te mau manu reva i roto i te reva.

Eaha te pinepineraa o te module?

800Mhz, 1.4G, e 2.4G.

Iaorana! E nehenehe anei e faatuati i te hoê pata hoho'a e te RTSP protocol i te taata afai parau?

E, paturu i te.

Can you remove the power and ethernet connector to keep the PCBA thinner?

E
1-20km drone uav wireless video data transceiver
drone wireless video data transceiver module

27kilometera 110kilometera NLOS FAQ

Te veavea roa ' ' e HDMI Te mau mana'o tauturu no te tuatapaparaa e te haapiiraa FAQ

Te mau hoho'a video aita e niuniu uira

TABULA NO TE MAU HOHO'A

DVB-T2 Module

ISDB-T Module

Tomite faatere no te mau hoho'a Peni