COFDM Relay Repeater
โมดูล COFDM Relay Repeater สำหรับเครื่องส่งและรับสัญญาณวิดีโอไร้สาย UAV ของโดรน Vcan1870
สารบัญ
บทนำ
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (เช่น. 400เมกะเฮิรตซ์) for communication with the relay, and a different frequency (เช่น. 700เมกะเฮิรตซ์) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
ลักษณะ
- Wireless Video COFDM Video Data demodulation and re-modulation
- การถ่ายโอนสัญญาณที่เสถียรใน NLOS และการเคลื่อนที่ด้วยความเร็วสูง (less than 600km/hour)
- ความถี่ในการทำงานที่ปรับได้, แบนด์วิดธ์, กำลังส่ง, ฯลฯ (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 มิลลิวินาที
- Widely frequency range 200Mhz-3000Mhz
- สนับสนุน อินพุต/เข้ารหัส/ส่งวิดีโอสองช่องพร้อมกัน
- แบนด์วิดธ์ 1Mhz-8Mhz ไม่จำเป็น
- Video signal repeater for long-distance
บทนำ
สเปค:
IO
ช่องรับสัญญาณ | Two SMA females (to receive the signal) |
เอาท์พุท RF | SconB หรือ SconC (to send out the signal again) |
control UART | 4ขั้วต่อ PIN PH1.25mm |
TTL 3.3V โดยค่าเริ่มต้น | 2PIN PH2.54mm phenix Connector |
TF-card | For firmware update |
Power led | red LED, constant light when the device is normally powered |
Link led | green led, blinks on transmitting the received data |
Demodulation and Modulation
Modulation Formats | COFDM(DVB-T) |
ผู้ให้บริการ | 2K |
แบนด์วิดธ์ | TTL 3.3V โดยค่าเริ่มต้น, TTL 3.3V โดยค่าเริ่มต้น |
FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
ช่วงเวลายาม | 1/32, 1/16, 1/8, 1/4 |
นักษัตร | QPSK, 16QAM, 64QAM |
บิตเรต | 0.5TTL 3.3V โดยค่าเริ่มต้น |
RF Received
คลื่นความถี่ | 160860MHz MHz ~ (need an extra down converter block for 860-2300Mhz) |
ปรับขนาดขั้นตอน | 1KHz |
ความไวแสง | -97±1dBm(BW=8MHz, QPSK, CR=2/3, จีไอ=1/16) for one channel and add 3dBm for two-channel |
RF Transmitted
คลื่นความถี่ | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
ปรับขนาดขั้นตอน | 1KHz |
Power out | Configurable, maximum -5dBm(subject to frequency) |
การติดตามและการควบคุม
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) และแบนด์วิธ (B1)
– TX Transmitted frequency (F2), แบนด์วิดธ์ (B2), FEC, ช่วงเวลายาม, constellation, and transmission power
ช่วงอุณหภูมิ
อินพุต/เข้ารหัส/ส่งวิดีโอสองช่องพร้อมกัน: 0° ถึง +70°C สภาพแวดล้อม
การเก็บรักษา: อินพุต/เข้ารหัส/ส่งวิดีโอสองช่องพร้อมกัน
ข้อกำหนดด้านพลังงาน
อินพุต/เข้ารหัส/ส่งวิดีโอสองช่องพร้อมกัน: 7~24VDC
การใช้พลังงาน: <250mA@12V
ลักษณะทางกายภาพ
ขนาด: 73x51x15mm
น้ำหนักรวม: 32.4 กรัม
คำสั่ง UART AT
The AT commands mainly used in the COFDM Wireless Relay Repeater are เอทีดีอาร์, เอทีเอสดี, เอทีจีดี, เอทีเอสอาร์, เอทีจีอาร์, and ATGB. For the introduction of specific commands, see the document.
คำถามที่พบบ่อย
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
The below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.