Analog FPV Video Transmitter and Receiver AHD CVBS Camera input 100Mhz-3.3G frequency

introduction

This is a newly launched analog video transmission module.
It is a module with a small size, humilis potentia consummatio, and simple frequency matching.
This product processes analog video signals with continuously changing time (including space) and amplitude as a source and channel to meet the needs of different scenarios.

feature

1. Multiple receivers can receive video signals at the same time\
2. humilis latency, wide frequency, humilis potentia consummatio, low heat generation
3. Stable transmission efficiency
4. Simple frequency matching
5. Small magnitudine (Corpus: 48mm x 32mm) (RX: 38mm x 28mm), humilis potentia consummatio
6. For simple frequency change, the starting frequency can be set through the serial port, et 4 frequency points can be cycled by pressing the button
7. High image quality and low signal interference rate

specification

1. Transmitter frequency range 100Mhz-3500Mhz (3.5G)
2. Receiver frequency range 100Mhz-3500Mhz (3.5G)
3. Default frequency range 400-900Mhz
4. Default power amplifier: 3-watt
5. Power supply 5V (not input 12V)
6. Video input source: AHD / CVBS camera
7. Frequency selection method: one button (four frequency preset loops chosen)

FAQ:

Q,. Can you make the analog FPV transmitter and receiver have a relay/repeater?

A: This is an analog model, there is no relay or repeater in the middle. If you need a relay or repeater for your FPV transmission system, please check the below model, which uses the COFDM digital transmission system, it can have a repeater. 3W PA 50KM