I mea e hōʻike maikaʻi ai i kā mākou mea kūʻai aku i ka mamao kākoʻo maoli a hoʻohana i ka hopena o ka 2W PA 30km lōʻihi kiʻi hoʻouna kiʻi transmitter a me ka mea hoʻokipa., Ua hana mākou i kahi hoʻokolohua maoli i kēia manawa a loaʻa kahi Meisha Peak, mai ʻaneʻi a hiki i kai o Nanʻao, ʻO ka mamao 27 kilomita. This site passes through Dapeng Bay, the line of sight is visible, and there are no obstructions. It just simulates the use of the transmitter in the air and the receiver on the ground.
Papa helu
How to choose the best long-range video transmitter and receiver?
Please consider the below points before you buy. Here are some tips for you.
1. EYI mamao o mai ka mea lawe a me ka mea lawe. The further the distance, the larger the power amplifier required; the larger the power amplifier, the higher the battery capacity requirement. No ia mea,, you need to determine the wireless transmission distance according to your own project or drone.
2. LOS or NLOS, Is there any obstacle between the transmitter and receiver? All the transmission distances mentioned on this site are based on the LOS environment. If your use environment is NLOS, you need a larger power amplifier to have stronger diffraction and penetration capabilities. no hoi, consider placing a relay repeater module in the middle.
3. One-way or two-way transmission type? One-way is like TV or radio, you can get the video or data at the receiver only, and two-way like mobile phones and the internet, you can get living video and send data or joystick control commands to the transmitter’s camera from the receiver side remotely. Two-way has a downlink and an uplink both.
4. PA, Power pahu hoʻonui leo, it is a signal enlarger, o kahi laʻana, 1 watts, 2 watts, 5 watts, 10 watts, 20 watts, big PA support longer range and strong signal to Anti-jamming. When choosing a power amplifier, you also need to consider power consumption, which will also increase the capacity of the battery.
5. kukuna, A longer and bigger antenna will offer you better signal sensitivity. Omnidirectional FRP fiberglass antennas or automatic antenna tracking pan/tilts are recommended.
6. UART control, Do you need to send the AT command from the computer or portable tablet receiver via uart?
Please check the below link for more details.
https://ivcan.com/request-a-quote-of-wireless-video-transmission/
a i 'ole WhatApp us to get free support.
Test Map measured 27km from the transmitter to the receiver
27 KM Test Video on YouTube
Features for drone long-range video transmitter and receiver
1. Ma muli o OFDM enehana, an IP RJ45 camera (Kāmera HD me ka ethernet) ua paipai.
2. Two-way broadband wireless link equipment supports 30Mbps. (Hiki i ka mea hoʻokipa ke kiʻi i ka leo-wikiō hoʻoiho, hiki iā ia ke hoʻouka i ka ʻikepili i ka mea loaʻa)
3. nānaina: 2Nā awa X Ethernet, 3X RS232 serial ports, hoʻo · kani leo (ʻO ka hana mana hou aʻe) Inā ʻo kā kāmela puka HDMI, a laila pono ia i kahi hāmeʻa encoder keu, hiki iā ia ke encode i ka wikiō HDMI a me ka hōʻailona leo i nā ʻikepili uila i kēia transmitter. Ma ka mea loaʻa, hiki iā ia ke hoʻohui pololei i kāu kamepiula a i ʻole NVR pololei paha, inā pono ʻoe i ka hoʻopuka i kahi monitor HDMI, a laila pono pū kekahi mea decoder keu e encode i ka ʻikepili kikohoʻe i ka wikiō wikiō a me ka hōʻailona leo.
4. Nā antennas pālua: SMA connector. ANT1 is the main antenna to work in transmitter mode, and the ANT2 is the auxiliary antenna to work in receive mode.
5. Pākuʻi pinepine hana uea ʻole: 1428~ 1448MHz (1.4G) a i ʻole 806 ~ 826MHz (800MHz) or 2.4Ghz, kākoʻo 'akomi alapine (frequency) hopping ana ma ke alapine (frequency) bana (FHSS).
6. Bandwidth bandwidth: 3MHz, 5MHz, 10MHz, 20MHz, kaʻana nā āpau āpau i ka bandwidth hana, aʻo ka palena palena nui o ka ʻōnaehana ʻo 30Mbps.
7. Modulation? aaeei: QPSK / QAM16 / QAM64 akomi ka hoʻololiʻana. Ke ʻano pūnaewele: point-to-point, pūnaewele hōkū kuhikuhi-kikoʻī, IP mesh pūnaewele, or relay networking. (makemake i 6 cameras and transmitters to one receiver application.)
8. Mana hoʻoili uea ʻole: 2-watt, 5-watt, 10-watt power amplifier.
9. Loaʻa ʻike ʻo Node: -103 ma 10MHz bandwidth.
10. Support AES128 encryption and decryption.
11. EYI mamao o: 15km/30km/80km/150km range optional.
12. Hiki ke ʻike ʻia ka hoʻonohonoho hoʻonohonoho a me ke kūlana hana uila ʻole ma o ka UI Pūnaewele o ka pūnaewele pūnaewele a i ʻole ka port serial.
13. Lako ikehu: DC24 ~ 30V, 28Paipai ʻia ka lako mana V, ʻoi aku ka liʻiliʻi o ka ʻai ma waena o 1.4A@28V, a hiki i ke koi lako mana piko instantaneous ke hiki i 2.8A@28V.
14. Size: 124*67.8*28.5mm o (me ka hoʻokaʻawale ʻana i ka hūlaha e hoʻonui nei i waho o ka pūpū, etc.).
15. 27 KM long-range wireless video transmitter receiver Weight: 250 nā huna
One of our clients bought our 2W PA (Power pahu hoʻonui leo) with 30km, up to 150km wireless video transmitter and receiver, but we can not find a 30km Line of sight place to test in our city, there are many high buildings. But luckily we found a place called Meishajian Peak, which is about 27 kilometers from the top of the mountain to the seaside.
About Meishajian, please check the below two links.
https://www.trip.com/travel-guide/attraction/shenzhen/meishajian-45198174/
Although the client chose a 2W-PA 30km transmission distance transceiver system, the test video is only 27km, So it is a 27 KM long-range wireless video transmitter-receiver.
Let us show you the transmitter and receiver first.
To show you clearly, we put the devices on one top and one bottom side for you.
There is two SMA antenna. ANT1 is the main antenna and works in transceiver mode. ANT2 is an auxiliary antenna that works in receive mode.
Aia 2 pieces of RJ45 ethernet input and power input. There is an Audio input and output connector, and the connector is three pieces of RS232 for UART data communication.
Before delivery, we take it out for testing and a live demo. It is hard to find a good place to test in our super large city, which needs 30km without obstacles. In this testing we have two teams, one team takes the IP camera and transmitter to the top of the mountain (Meishajian Peak), and another team takes the receiver and computer to the seaside (Nan’ao).
Where is the Air Unit Transmitter and Camera?
We put the transmitter, pahupaʻiwikiō, and rechargeable battery on the rock.
On the map, we can see the distance measurement is 27.85km.(17.30 mile)
At the top of the mountain, the weather is bad and full of fog.
Here I use our last time demo video to show you our position and environment.
It was a sunny day, it was easy to watch the seaside.
Hope you see where are the transmitter and camera now.
That time we were at the top of the mountain to test another composite CVBS video transmitter COFDM-912T.
It also tested and passed 26km from the transmitter and receiver.
Today The set we tested is a long-range video data link system on the base of OFDM, which means the transmitter and receiver are the total same and support RJ45 IP web camera video input via ethernet connector.
If your camera has HDMI output, then it needs an extra HDMI encoder IP RJ45 output board, hiki iā ia ke encode i ka wikiō HDMI a me ka hōʻailona leo i nā ʻikepili uila i kēia transmitter.
Ma ka mea loaʻa, hiki iā ia ke hoʻohui pololei i kāu kamepiula a i ʻole NVR pololei paha, We used a notebook computer monitor as the receiver screen, RTSP player, or VLC player to play the living video streaming from the transmitter and camera.
This model Networking mode support point-to-point and point-to-multipoint star network.
Point to point means one transmitter and one receiver, Point to multipoint means up to 6 cameras from the different transmitters and one receiver at the Security monitoring center.)
They are two-way broadband wireless video data audio links, the receiver can get the audio and video download, and it also can upload the data to the transmitter, o kahi laʻana, some people need to control the PTZ camera via the joystick from the receiver.
Where is the Ground Unit Receiver and Computer (ground control station)?
At the receiver position, which is at the seaside, we use the two fiberglass antennae as the receiver’s antenna. Because the wireless video receiver supports RJ45 output, we can connect it by computer directly, with no need HDMI monitor.
The link and operation are very simple.
Now we will show you the video of the computer, it is from the computer recording screen software.
At the parameter of transmitter and receiver, there are two data in red, which shows the signal strength. Another import parameter shows the distance between the transmitter and the receiver.
This distance is calculated based on the time when the receiver sends some packets to the transmitter and receives their response from the transmitter.
Now we will show you the transmitter and receiver working details. The transmitter IP address is 192.168.1.12 and the receiver IP address is 192.168.1.11.
If you have any questions about our 27 KM long-range wireless video transmitter receiver, e ʻoluʻolu e hoʻokaʻaʻike mai iā mākou. I will show you the details in the next video.
What can you operate at the Web UI?
Do you want to see a 110km Real Test video?
Which model supports 150km?
Long-Range Wireless Video Transmitter and Receiver for camera datasheet download
Nā Hoʻohana maʻamau a me nā hiʻohiʻona hoʻohana
-
15km 30km 80km 150km lōʻihi lōʻihi uwea wikiō transmitter hoʻokipa lawe transceiver PA 2W 5W 10W
-
ʻOi aku ka maikaʻi o ka FPV Video Transmitter Module 170-860Mhz Wireless RF leo wikiō Transmitter no ka FPV Camera 3W PA 50km
-
10W PA 150KM lewa wikiō ikepili loulou loloa UAV uea hoʻouna transmitter loaʻa broadband tactical handhold
-
UAV drone video link module module wireless video transmitter and receiver for camera long-long TDD transceiver two-way vcan1401
-
COFDM wikiō transmitter-loaʻa AV ma HDMI waho FPV, ʻO 10km-15km-30km ʻoi aku ka liʻiliʻi a lōʻihi loa COFDM-912T
-
30Km lōʻihi loa COFDM HDMI Mea hoʻolele wikiō ʻole i ka loaʻa piha ʻana i ke wikiō wikiō TX RX no UAV Drone 1080P 908T
-
ʻElua ala ʻelua ʻaoʻao UAV ʻikepili wikiō ʻike ʻole RC Control Link module lōʻihi bidirectional transceiver Transmitter-Receiver Vcan1681
-
COFDM nā pūnaewele Video HDMI lēkio leo HI EYI HDMI HD 1080p CVBS H264 Encoder COFDM-907T
-
Mea hoʻouna wikiō ʻole a loaʻa no ka pahupaʻikiʻi, HDMI HD H265 264 encoder 1W/2.5W PA 1080P60 Vcan1726
-
30-millisecond Drone UAV HDMI Mea hoʻolele wikiō uea ʻole Ultra-haʻahaʻa-latency ʻōnaehana uila uila Vcan1729
-
ʻO ka loulou ʻikepili wikiō uwea Drone mesh 150-200km ka lōʻihi o ke kikowaena kikowaena ad hoc transceiver
-
PA rf Power Amplifier no DVB-T COFDM TX Transmitter hoʻouna 1-2-5-10-20-30-40-50-watt
-
COFDM Modulator Demodulator Module Encoder Decoder HDMI CVBS AV Input AES 256 FHD RF kahe ana
-
HDMI To IP encoder modulator CVBS H.265 H.264 encoding papa pcba Ethernet RSTP UDP no UAV Drone Robotic
-
ʻIkepili wikiō ʻike ʻole ʻole UAV RC loulou no ka Drone 15-20-30-50-100-150km 1.4G / 2.4G / 5.8G transceiver transmitter-receiver Vcan1818
-
COFDM uea Ethernet hoʻoheheʻe māmā module 100M bps RJ45 FDD mea hoʻouna a me ka mea hoʻokipa.
-
COFDM IP uwea video transmitter module One-way Ethernet transparent transmission network port vcan1816
-
22km ikepili wikiō uea ʻole RC mana loulou no ka ip ethernet pahupaʻiwikiō a me ka mea hoʻokipa fhss Vcan1806