COFDM Relay Repeater
I-COFDM Relay Repeater module ye-drone UAV isidlulisi sevidiyo esingenantambo nomamukeli Vcan1870
Okuqukethwe
Isingeniso
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (isb. 400MHz) for communication with the relay, and a different frequency (isb. 700MHz) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
Isici
- Wireless Video COFDM Video Data demodulation and re-modulation
- Ukudluliswa kwesignali okuzinzile ku-NLOS nokuhamba ngesivinini esiphezulu (less than 600km/hour)
- Imvamisa yokusebenza elungisekayo, komkhawulokudonsa, amandla okudlulisa, njll (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 millisecond
- Widely frequency range 200Mhz-3000Mhz
- Amaprosesa asekelwe I-HDMI noma i-SDI noma i-CVBS
- Komkhawulokudonsa 1Mhz-8Mhz ozikhethela
- Video signal repeater for long-distance
Isingeniso
Ukucaciswa:
IO
RF okokufaka | Two SMA females (to receive the signal) |
Ukukhishwa kwe-RF | I-SconB noma i-SconC (to send out the signal again) |
control UART | 4I-PIN PH1.25mm Isixhumi |
Okokufaka Kwevidiyo Ehlanganisiwe | 2I-PIN PH2.54mm phenix Isixhumi |
Ikhadi le-TF | Ukuze uthole isibuyekezo se-firmware |
I-power led | red LED, constant light when the device is normally powered |
Isixhumanisi siholwa | green led, blinks on transmitting the received data |
I-Demodulation kanye ne-Modulation
Amafomethi Wokushintshashintsha | COFDM(DVB-T) |
Abathwali | 2K |
Komkhawulokudonsa | Okokufaka Kwevidiyo Ehlanganisiwe, Okokufaka Kwevidiyo Ehlanganisiwe |
FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
Guard isikhawu | 1/32, 1/16, 1/8, 1/4 |
Constellation | QPSK, 16Unjiniyela: QAM, 64Unjiniyela: QAM |
Ama-Bitrate | 0.5Okokufaka Kwevidiyo Ehlanganisiwe |
I-RF Yamukelwe
imvamisa Amabhendi | 160MHz ~ 860MHz (need an extra down converter block for 860-2300Mhz) |
Ukushuna usayizi wesinyathelo | 1kHz |
ukuzwela | -97±1dBm(BW=8MHz, QPSK, I-CR=2/3, I-GI=1/16) esiteshini esisodwa bese wengeza i-3dBm yamashaneli amabili |
I-RF idluliselwe
imvamisa Amabhendi | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
Ukushuna usayizi wesinyathelo | 1kHz |
Power out | Kuyalungiseka, esiphezulu -5dBm(ngaphansi kwemvamisa) |
Ukuqapha nokulawula
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) kanye nomkhawulokudonsa (B1)
– TX Transmitted frequency (F2), komkhawulokudonsa (B2), FEC, unogada isikhawu, constellation, and transmission power
Izinga lokushisa ububanzi
I-HDMI noma i-SDI noma i-CVBS: 0° kuya +70°C Ambient
Storage: I-HDMI noma i-SDI noma i-CVBS
Izidingo zamandla
kungabandakanyi izixhumi eziphuma ebhodini: 7~ 24VDC
Power ukusetshenziswa: <250mA@12V
Izici Physical
Ubukhulu: 73x51x15mm
Isisindo esikhulu: 32.4 amagremu
Imiyalo ye-UART AT
The AT commands mainly used in the COFDM Wireless Relay Repeater are I-ATDR, I-ATSD, I-ATGD, I-ATSR, I-ATGR, and ATGB. For the introduction of specific commands, see the document.
Imibuzo Evame Ukubuzwa
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
The below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.