Wireless video transmitter and receiver

Thanks.

Distance from drone to the ground station: maximum 20~30km, Wireless working frequency: 300Mhz, P2P or point to multi-point, -20°C ～+55°C Working temperature, -40°C ～+70°C Storage Temperature, Configurable channel bandwidth, IP mesh is optional, HDMI camera input. Small size around 800gram and a size around 150×100×50mm. Explosion-proof box for the transmitter with green army color and military-grade.

Our Vcan1729 meets all of your demands.
https://ivcan.com/p/30-millisecond-drone-uav-hdmi-wireless-video-transmitter/

And the ability to connect to the Radiomaster tx16s remote via twisted pair or USB.
To spread the remote control and the transmitter at a distance.
The range of radio communication should be at least 10 km with a very noisy radio broadcast.

Interested in a video transmitter and a video receiver at frequencies 2.1 – 2.2Ghz, and 4.8 – 4.9Ghz or non-standard frequencies that you can offer us for use on UAVs. Also matched antennas to them. Video receivers have the ability to connect either an AV cable, Fatshark, or Skyzone glasses, or the ability to manufacture a ready-made helmet with a video receiver for these frequencies. Video Transmitter: Smart Audio support: yes
Dimensions: ~40×23×10.5mm
Weight: ~15 g.

Repeater. Product requirements: must transmit radio (300 – 320 Mhz) and video (2.1 – 2.2 or 4.8 – 4.9 GHz) communication on the same frequencies as previously requested. Or non-standard frequencies that you can offer us. The input voltage is from ~5 to 30 volts. As well as matched antennas to the kit.
Thanks.

Bi-Directional Ethernet Support
Bi-Directional Rs-232 Support
Minimum data rate 4Mbps
Minimum range 30 Km
compact size like 70mm * 50 mm * 20 mm
having a price less than 1500 USD

Ok

I am licensed on 6.425 – 6.525 GHz and I usually would have a 10 or 20 MHz channel available. Would it be possible to do Bi-directional Ethernet traffic in a 10 or 20 MHz channel? Is it possible to set up the transmitter to use 8MHz in one direction and 2 MHz in the other direction (return channel)? If 6.4GHz is not possible I will use 5.805 to 5.845 GHz

Is it possible to put together an auto-tracking system? How does the steerable antenna know where to point? I’m interested in a directional receive antenna with a narrow look angle (like 3 to 5 degrees) and high gain. The auto-tracking antenna would be installed on a high mountaintop. The remote unit may be stationary in the city or on a moving boat.

We would like to cover an area of 50-60km and I’m looking for 50-100Mbit of usable capacity on the link

Thanks.

Thanks.

Please let us know if you can make systems with custom frequencies
We would like options for
902 – 928Mhz
1.15Ghz to 1.4Ghz
2.2Ghz to 2.5Ghz
4.9Ghz to 6Ghz
We know these would be separate systems but would like to know if you can build these for us.
We would also like options for 200mW Transmitters: 1Watt Transmitters and 2Watt Transmitters.
We would like to know if you can make custom systems with HDMI or HD-SDI video input for the Transmitter and both HDMI & HD-SDI video outputs for the Receiver.
One final question is can you decrease the Video Latency end to end to 100ms or less? Most of our customers need this.

TX900 is recommended.

less than 50km, Line of sight, two-ways RJ45, 15 watts.

First, we fill a balloon up with helium and attach a parachute and sensors to it. Later we release it and it goes high up into the air until the balloon pops and comes back to the ground, The time in the air can be 3-6 hours, And the distance varies a lot.

Thanks.

Supported

TX900 supports MESH radio.

I will send the quotation by email.

ok

Thanks.

In particular, we require the onboard electronic hardware to weigh no more than 600 grams. We would appreciate a detailed block diagram of the system’s connectivity and a competitive price.
We seek an onboard and ground station system that can operate at a range of 40 kilometers.

Please check our TX900, https://ivcan.com/p/15km-30km-long-distance-wireless-video-transmitter-receiver-transmission-transceiver/

COFDM-908T is recommended.

FPV1887 is recommended.

Thanks. I will quote you by email.

Thanks

1. 15km and 150km are different Moningcore modules, but the appearance and structure are the same.

2. Just use a 2W amplifier for 15km. A 10W power amplifier is required for 150km, and a 5W power amplifier is required for 100km.

3. 50km 5W power amplifier or even 2W power amplifier is enough. A 10W power amplifier is not required, but if you want a 10W power amplifier, it is also available. The signal strength will be stronger.

Hello. My name is Andrew. I am the leading manager of purchasing equipment for our company, which is rapidly growing and developing in the Ukrainian market, and we are entering the markets of Europe and America. We are looking for test samples for our aircraft of various types and purposes.
We are now actively looking for stable and high-quality data link suppliers for video and telemetry transmission.
Currently, we manufacture about 500 aircraft per year. These indicators are growing every year, so we are looking for interesting and good solutions for UAV.
If you have the opportunity to offer test samples for the Drone and the ground station of the station, we will be very happy. And cooperation is possible after successful testing by our engineers.

Vcan1988 is recommended.