COFDM Relay Repeater
ڈرون UAV وائرلیس ویڈیو ٹرانسمیٹر اور رسیور Vcan1870 کے لیے COFDM ریلے ریپیٹر ماڈیول
فہرست کا خانہ
تعارف
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (مثلا. 400میگاہرٹز) for communication with the relay, and a different frequency (مثلا. 700میگاہرٹز) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
نمایاں کریں
- Wireless Video COFDM Video Data demodulation and re-modulation
- NLOS میں مستحکم سگنل کی منتقلی اور تیز رفتار حرکت (less than 600km/hour)
- سایڈست کام کرنے کی فریکوئنسی, بینڈوڈتھ, ٹرانسمیشن طاقت, وغیرہ (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 ملی سیکنڈ
- Widely frequency range 200Mhz-3000Mhz
- سپورٹ ایمبیڈڈ HDMI یا ایمبیڈڈ SDI یا AV آڈیو
- بینڈوڈتھ 1Mhz-8Mhz اختیاری
- Video signal repeater for long-distance
تعارف
تفصیلات:
IO
آریف ان پٹ | Two SMA females (to receive the signal) |
آر ایف آؤٹ پٹ | SconB یا SconC (to send out the signal again) |
control UART | 4PIN PH1.25mm Connector |
پاور ان | 2PIN PH2.54mm phenix Connector |
TF-card | For firmware update |
Power led | red LED, constant light when the device is normally powered |
Link led | green led, blinks on transmitting the received data |
Demodulation and Modulation
ماڈیولیشن فارمیٹس | COFDM(DVB-T) |
کیریئرز | 2K |
بینڈوڈتھ | 1MHz سے 8MHz تک قابل ترتیب, 1KHz کی طرف سے قدم |
FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
گارڈ وقفہ | 1/32, 1/16, 1/8, 1/4 |
نکشتر | QPSK, 16QAM, 64QAM |
بٹریٹس | 0.5ایم بی پی ایس سے 31.67 ایم بی پی ایس |
RF Received
فریکوئنسی بینڈ | 160میگاہرٹز ~ 860MHz (need an extra down converter block for 860-2300Mhz) |
ٹیوننگ مرحلہ سائز | 1kHz کے |
حساسیت | -97±1dBm(BW=8MHz, QPSK, CR=2/3, GI=1/16) for one channel and add 3dBm for two-channel |
RF Transmitted
فریکوئنسی بینڈ | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
ٹیوننگ مرحلہ سائز | 1kHz کے |
Power out | Configurable, maximum -5dBm(subject to frequency) |
نگرانی اور کنٹرول
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) اور بینڈوتھ (B1)
– TX Transmitted frequency (F2), بینڈوڈتھ (B2), FEC, گارڈ وقفہ, constellation, and transmission power
درجہ حرارت کی حد
ایمبیڈڈ HDMI یا ایمبیڈڈ SDI یا AV آڈیو: 0° سے +70°C محیط
ذخیرہ: ایمبیڈڈ HDMI یا ایمبیڈڈ SDI یا AV آڈیو
بجلی کی ضروریات
ایمبیڈڈ HDMI یا ایمبیڈڈ SDI یا AV آڈیو: 7~24VDC
طاقت کا استعمال: <250mA@12V
جسمانی خصوصیات
ابعاد: 73x51x15mm
مجموعی وزن: 32.4 گرام
UART AT commands
The AT commands mainly used in the COFDM Wireless Relay Repeater are اے ٹی ڈی آر, اے ٹی ایس ڈی, اے ٹی جی ڈی, اے ٹی ایس آر, اے ٹی جی آر, and ATGB. For the introduction of specific commands, see the document.
اکثر پوچھے گئے سوالات
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
The below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.