Analog FPV Video Transmitter and Receiver AHD CVBS Camera input 100Mhz-3.3G frequency

Introduction

This is a newly launched analog video transmission module.
It is a module with a small size, low power consumption, and simple frequency matching.
This product processes analog video signals with continuously changing time (including space) and amplitude as a source and channel to meet the needs of different scenarios.

Характеристика

1. Multiple receivers can receive video signals at the same time\
2. Low latency, wide frequency, low power consumption, low heat generation
3. Stable transmission efficiency
4. Simple frequency matching
5. Small size (Техас: 48mm x 32mm) (ГХ: 38mm x 28mm), low power consumption
6. For simple frequency change, the starting frequency can be set through the serial port, and the 4 frequency points can be cycled by pressing the button
7. High image quality and low signal interference rate

Спецификация

1. Transmitter frequency range 100Mhz-3500Mhz (3.5Жадем)
2. Receiver frequency range 100Mhz-3500Mhz (3.5Жадем)
3. Default frequency range 400-900Mhz
4. Default power amplifier: 3-watt
5. Power supply 5V (not input 12V)
6. Video input source: AHD / CVBS camera
7. Frequency selection method: one button (four frequency preset loops chosen)

ЧАВО:

Юан. Can you make the analog FPV transmitter and receiver have a relay/repeater?

Нош: This is an analog model, there is no relay or repeater in the middle. If you need a relay or repeater for your FPV transmission system, please check the below model, which uses the COFDM digital transmission system, it can have a repeater. 3W PA 50KM