Erġa' Ikteb il-programm ġdid ta' aġġornament tal-firmware għaċ-chipset għal kaxxa tat-tv diġitali DVB-T2 jew ISDB-T pass pass

Erġa' Ikteb il-programm ġdid ta' aġġornament tal-firmware, għaliex?

When do you need to Re-Write the program on your tv box?

If you upgrade the wrong Firmware or your tv box programmable chipset has lost the firmware, għandek bżonn terġa 'tikteb il-firmware fil-kaxxa tat-tv tiegħek mill-kompjuter. Jekk jogħġbok iċċekkja l-operazzjoni fil-video hawn taħt.

A computer or tv box can upgrade with new firmware as it has the original firmware inside. If the device has lost or installed the wrong firmware, it can not upgrade to new firmware again. Except that the device’s engineer can offer you the new firmware but load it from the USB stick. Just like your computer os has been lost or a hard disk has been formatted, you can use a USB with the operating system to load and re-write a new firmware to the device. The below operation is similar to operation, from the computer instead of using a USB stick with the operating system.

Re-Write software to your tv box video guide.

Re-Write new firmware to your tv box steps.

Kultant, if you upgrade the wrong firmware to the tv box or the program chipset loses the firmware, you have to re-write the new upgrade program to your tv box. This video shows the rewrite operation via the chipset programmer step by step.

• Pass 1, Prepare the chipset programmer, TV boxboard, and multimeter pen.
• Pass 2, Connect the chipset programmer to the computer and power it. When the chipset programmer lights up blue, it means the chipset programmer is ready.
• Pass 3, At the computer, open the chipset programmer burning tool.
• Pass 4, Click the communication device configuration to find the device.
• Pass 5, Click on the MCU model, the model here should be the same as the MCU model on the TV box board.
• Pass 6, Load the software. and click download.
• Pass 7: Power off the chipset programmer and power it on again.
• Pass 8, Connect the wire from the chipset programmer to the tv board. The square pin of the wire is aligned with the ground.
• Pass 9, Turn on the DC power supply and adjust the voltage to between 3.3~4.5V.
• Pass 10, Connect the negative pole (iswed) of the DC voltage to the ground and the positive pole (aħmar) to the positive pole of the power supply.
• Pass 11, Press the white button on the chipset programmer. The chipset programmer lights up blue and hears a “beep”, which means the upgrade is complete.

The operations should be operated by a professional person. Or ask for assistance from your tv box supplier. Thanks for watching the video about the Re-Write program’s new updated firmware.

If you have any questions about the above operation, jekk jogħġbok ikkuntattjana.

For more details, please also visit isdb-t.com