COFDM Relay Repeater
ड्रोन UAV वायरलेस व्हिडिओ ट्रान्समीटर आणि रिसीव्हर Vcan1870 साठी COFDM रिले रिपीटर मॉड्यूल
सामग्री सारणी
परिचय
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (उदा. 400मेगाहर्ट्झ) for communication with the relay, and a different frequency (उदा. 700मेगाहर्ट्झ) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
वैशिष्ट्य
- Wireless Video COFDM Video Data demodulation and re-modulation
- NLOS मध्ये स्थिर सिग्नल ट्रान्सफर आणि हाय-स्पीड मूव्हिंग (less than 600km/hour)
- समायोज्य काम वारंवारता, बँडविड्थ, प्रसारण शक्ती, इ (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 मिलिसेकंद
- Widely frequency range 200Mhz-3000Mhz
- समर्थन व्हिडिओ स्वरूप
- बँडविड्थ 1Mhz-8Mhz पर्यायी
- Video signal repeater for long-distance
परिचय
तपशील:
IO
आरएफ इनपुट | Two SMA females (to receive the signal) |
आरएफ आउटपुट | SconB किंवा SconC (to send out the signal again) |
control UART | 4PIN PH1.25mm कनेक्टर |
पर्यायी RS232 | 2PIN PH2.54mm phenix Connector |
TF-card | For firmware update |
Power led | red LED, constant light when the device is normally powered |
Link led | green led, blinks on transmitting the received data |
Demodulation and Modulation
मॉड्यूलेशन स्वरूप | COFDM(DVB टी) |
वाहक | 2के |
बँडविड्थ | पर्यायी RS232, पर्यायी RS232 |
FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
गार्ड मध्यांतर | 1/32, 1/16, 1/8, 1/4 |
ग्रह | QPSK, 16QAM, 64QAM |
बिटरेट्स | 0.5पर्यायी RS232 |
RF Received
वारंवारता बँड | 160MHz ~ 860MHz (need an extra down converter block for 860-2300Mhz) |
ट्युनिंग चरण आकार | 1kHz |
संवेदनशीलता | -97± 1 डीबीएम(BW=8MHz, QPSK, CR=2/3, GI=1/16) for one channel and add 3dBm for two-channel |
RF Transmitted
वारंवारता बँड | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
ट्युनिंग चरण आकार | 1kHz |
Power out | Configurable, maximum -5dBm(subject to frequency) |
देखरेख आणि नियंत्रण
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) आणि बँडविड्थ (B1)
– TX Transmitted frequency (F2), बँडविड्थ (B2), FEC, गार्ड मध्यांतर, constellation, and transmission power
तपमान
व्हिडिओ स्वरूप: 0° ते +70°C वातावरणीय
स्टोरेज: व्हिडिओ स्वरूप
वीज आवश्यकता
व्हिडिओ स्वरूप: 7~24VDC
वीज वापर: <250mA@12V
शारीरिक गुणधर्म
परिमाण: 73x51x15mm
एकूण वजन: 32.4 ग्रॅम
UART AT आदेश
The AT commands mainly used in the COFDM Wireless Relay Repeater are ATDR, ATSD, ATGD, ATSR, ATGR, and ATGB. For the introduction of specific commands, see the document.
वारंवार विचारले जाणारे प्रश्न
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
The below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.