How to burn your own firmware to the RV1126 AI IPC camera
The first burning needs to use DriverAssistant to install the driver.
Table of Contents
There are three ways to enter the burning mode:
1. reboot loader
After entering the system, run the reboot loader, and automatically enter the loader mode after restarting
After powering on, quickly press Ctrl + C to interrupt the Uboot startup, and then type the download command.
2. Short Circuit
Power off, use tweezers to short the two points in the red circle above, and power on
Open RKDev_Tool, and it will display “found a Maskrom device” or “found a Loader device”:
Select “Upgrade Firmware”:
Click on “Firmware”:
A file selection dialog window pops up, select update.IMG, it may be stuck for a few seconds to load the firmware.
Then click upgrade:
You can see that the log on the right starts to show the burning process.