COFDM relee repiiteri moodul drooni UAV juhtmevaba videosaatja ja vastuvõtja jaoks Vcan1870
COFDM Relay Repeater
COFDM relee repiiteri moodul drooni UAV juhtmevaba videosaatja ja vastuvõtja jaoks Vcan1870
Sisukord
sissejuhatus
The module is a relay module, not a completed item. Customers need to add a power amplifier, filters, and receiving and transmitting antennas for it to work effectively. These need to be customized according to the two working frequencies selected by the customer.
To prevent interference, the drone employs a single frequency (nt. 400Mhz) for communication with the relay, and a different frequency (nt. 700Mhz) for communication between the relay module with the receiver. The separation between the two should be as large as possible.
tunnusjoon
- Wireless Video COFDM Video Data demodulation and re-modulation
- Stable signal transfer in NLOS and high-speed moving (less than 600km/hour)
- Reguleeritav töösagedus, ribalaius, ülekandevõimsus, jne (Special Parameter Configure Tool or UART STM32 LoRA )
- Lowest latency 200-300 millisekundit
- Widely frequency range 200Mhz-3000Mhz
- Toetus Saadaval on muud vahemikud 200–860 MHz
- Bandwidth 1Mhz-8Mhz vabatahtlik
- Video signal repeater for long-distance
sissejuhatus
spetsifikatsioon:
IO
| RF sisendi | Two SMA females (to receive the signal) |
| RF väljund | nagu kaitseintervall (to send out the signal again) |
| control UART | 4PIN PH1,25 mm pistik |
| HDMI- ja SDI-sisenditest saab valida ainult ühe | 2PIN PH2.54mm phenix Connector |
| TF-card | For firmware update |
| Power led | red LED, constant light when the device is normally powered |
| Link led | green led, blinks on transmitting the received data |
Demodulation and Modulation
| Modulation Formats | COFDM(DVB-T) |
| Kandjad | 2K |
| Bandwidth | HDMI- ja SDI-sisenditest saab valida ainult ühe, HDMI- ja SDI-sisenditest saab valida ainult ühe |
| FEC | 1/2, 2/3, 3/4, 5/6, 7/8 |
| Guard intervalli | 1/32, 1/16, 1/8, 1/4 |
| tähtkuju | QPSK, 16QAM, 64QAM |
| Bitrates | 0.5HDMI- ja SDI-sisenditest saab valida ainult ühe |
RF Received
| sagedusalade | 160MHz ~ 860MHz (need an extra down converter block for 860-2300Mhz) |
| Tuning Step size | 1kHz |
| tundlikkus | -97±1dBm(BW=8MHz, QPSK, CR=2/3, GI=1/16) for one channel and add 3dBm for two-channel |
RF Transmitted
| sagedusalade | 200MHz~2300MHz(other bands can be supported with special manufacturing) |
| Tuning Step size | 1kHz |
| Power out | Configurable, maximum -5dBm(subject to frequency) |
Monitoring and control
This COFDM relay repeater module can complete setup with our Parameter Configure Tool or STM32+LoRA (or other devices) via control uart. With our parameter configure too, the following parameters can be set:
– RX Received frequency (F1) and bandwidth (B1)
– TX Transmitted frequency (F2), ribalaius (B2), FEC, valvur intervalli, constellation, and transmission power
Temperatuuri vahemik
Temperatuuri vahemik: 0° to +70°C Ambient
ladustamine: Temperatuuri vahemik
Power requirements
Temperatuuri vahemik: 7~24VDC
Energiatarve: <250mA@12V
Füüsikalised omadused
mõõdud: 73x51x15mm
brutokaal: 32.4 grammi
UART AT käsud
The AT commands mainly used in the COFDM Wireless Relay Repeater are ATDR, ATSD, ATGD, ATSR, ATGR, and ATGB. For the introduction of specific commands, see the document.
KKK-d
- Our COFDM Video Transceiver relay repeater supports 170-860Mhz. The COFDM transmitter also supports 2300Mhz, but the COFDM receiver only supports up to 860Mhz, 861-930Mhz receiver our COFDM-221 supports, over 930Mhz-2300Mhz needs to plus the frequency downconverter block to support.
- Our COFDM relay repeater module supports all the COFDM transmitters and receivers, the transmission distance depends on your external power amplifier and filter support.
The below model is good for a two-way TDD bidirectional link of the Wireless relay transmitter and receiver or wireless transmitter and receiver relay repeater.
Seotud tooted
Mesh Ad Hoc võrk
Mesh Ad hoc võrgumoodul Käeshoitav kaasaskantav install Vcan1874
