All COFDM modules(whether transmitter modules or receiver modules) can have their parameters configured through the uart port. These parameters include modulation setup, συχνότητα εργασίας, εύρος ζώνης, transmitted gain, H264 code rate, encryption and decryption password, uart baud rate, και τα λοιπα. provides three models of uart config panel for different applications and cases, named SconA, SconB, and SconC.
έχουμε ήδη στείλει το ενημερωμένο λογισμικό και λύσαμε αυτό το πρόβλημα.
Uart config panel | SconA | SconB | SconC |
Απεικόνιση | 0.96 ιντσών OLED | 8 digit 8-segments LED | 1.54 ιντσών OLED |
Διαστάσεις | 54*23.4mm | 85*50*22mm | 65*31mm |
Κλειδιά | 3 | 4 | 3 |
Supported modules | All COFDM modules | ||
Παροχή ηλεκτρικού ρεύματος | Powered from COFDM module(5V) | ||
Connection interface | Uart signal with VDD, 4 PIN PH1.25 connector or USB connector or just 4 solder holes | ||
Parameters configurable | όλα | parts of | όλα |
SconA
The SconA config panel has a 0.96-inch OLED display, με 3 operation buttons. SconA config panel dimensions: 54*23.4mm, it does not include the connectors out of the board edge. For different COFDM modules and device case designs, it should use one of the three connecting interfaces:
- 4 PIN PH1.25 connector(TTL uart), use this one to connect the module with TTL control UART.
- USB connector(RS232 uart), use this one to connect the module with the RS232 control UART in the USB connector.
- 4 PIN holes(RS232 uart), use this one to connect the module with RS232 control UART for compact device case design.
SconB
The SconB config panel has an 8-digit 8-segments LED display, με 4 operation buttons. SconB config panel is installed in a plastic outer shell, with dimensions 85*50*22mm. For different COFDM modules, it should use one of the two connecting interfaces:
- 4 PIN PH1.25 connector(CFG2, TTL uart), use this one to connect the module with TTL control UART.
- USB connector(CFG1, RS232 uart), use this one to connect the module with the RS232 control UART in the USB connector.
έχουμε ήδη στείλει το ενημερωμένο λογισμικό και λύσαμε αυτό το πρόβλημα.
SconC
The SconC config panel has a 1.54-inch OLED display, με 3 operation buttons. SconC config panel dimensions: 65*31mm, it does not include the connectors out of the board edge. For different COFDM modules and device case designs, it should use one of the three connecting interfaces:
- 4 PIN PH1.25 connector(TTL uart), use this one to connect the module with TTL control UART.
- USB connector(RS232 uart), use this one to connect the module with the RS232 control UART in the USB connector.
- 4 PIN holes(RS232 uart), use this one to connect the module with RS232 control UART for compact device case design.